Piedmont plastics, I recognize that green set anywhere.

I worked the old version for 5yrs. DECORBOND Particleboard.... methinks about 90 lbs/sheet. Tough job, requiring inspection of finish on both sides, prior to loading. EPIC2 was the programming then. I am a dinosaur.

brillant stuff, thanks for sharing this, what is it that you are making?

Please provide me all detail and specifications of beam saw machine .

No need to hammer the boards straight just trim the back edge

@thomasprestoniii4903

Жыл бұрын

It’s good practice for 2 reasons. Grained directional material and plastic industry utilizes about 90% nominal cutting sizes for minimum drop, so sometimes there is no more than a dusting off the front and back.

Dont hammer the flywood it cause missalignment the reference guide or the clamping.

@thomasprestoniii4903

Жыл бұрын

The Pusher will adjust to proper cut position after it clamps. It has dual encoder measuring system and always knows where it is.

@gorsanimpaxwoodworkingmach1477

11 ай бұрын

Hii sir

Please give full information video about this software 🙏🙏

@thomasprestoniii4903

Жыл бұрын

Send me your email as a private message. I’ll send you 15 training videos I made for this particular software and machine.