Basics of 3D Puff embroidery. Talking digitizing and embroidering simple design using Tajima TMBP2
#embroidery #tajima #diy #machineembroidery #howtoembroider
Heyoooo, today we go over a little bit about how to digitize simple designs to embroider 3D puff. Of course, there's a ton of things to go over when digitizing and embroidering puff but today we go as simple as simple as possible.
Пікірлер: 17
very nice. One day I might be up to this level of work.
@tkstitch
Ай бұрын
Thank you! And trust me I’m no pro, there’s a whole stack of items I’ve messed up and practiced on to start getting decent results. Just gotta keep messing up and getting better 💪
@6:02 I REALLY appreciate you leaving this part in. :) That hat is crispy for sure, great job! I took notes. :)
Nice job
Very nice ! Thanks
@tkstitch
3 ай бұрын
Thank YOU!
What was that tweezer thing that you cut the thread with at the end? And where do I purchase that?
@tkstitch
13 күн бұрын
We’ve had these for a while I honestly don’t remember where they came from but yea they’re just regular pointy tweezers. Just saw they have similar ones on Amazon
Nice , reminds me of a Knight from a chessboard ….
@tkstitch
3 ай бұрын
Truuueee I did not think abut it like that, I like it!
It’s really nice .. can you send me the dst please 🙏 .. best regards from Germany
what is your max measure of your satin stitch in the head of the horse?
@tkstitch
3 ай бұрын
The widest part is about .80 inches or 20.2mm
Where did you get the tape from?
@tkstitch
3 ай бұрын
Its called something like "heat tape for sublimation" it's really used for holding down things you're going to heat press but I have a ton so it works for this too.
Is it possible to get the design?
😂😂even i forgot about the Foam 😂😂😂