No video
Ball Joint Replacement: Citroen Relay Fiat Ducato Peugeot Boxer Ram Promaster Van
here we come to look at a grinding noise on this Citroen relay van.
see it's the ball joint that has failed and we take you through the process of how we replace it
Пікірлер: 20
Nice to see you using torque settings.
Haven’t seen a ball joint that badly worn in years it must have been knocking and banging for a good while good job that you got to it in time a decent sized pot hole and that would have failed
Great video...very informative. Can you tell me what impact wrench you use please.
Nice work 👍
Good video thanks 👍👍
Think the ballpoint is gone in my mazda 5 I've also got a lower booth an seal that's got to get done. Good vid again really enjoyin these tonight with tea and biscuits. #SUPERTECH
46mm hub nut
@sivy8611
3 жыл бұрын
On mine it's not more like 50mm
Does wheel alignment need doing after replacing ball joint? There must be some adjustment in the positioning of the 3 hole plate to the hub?
@OneManEngineering
Жыл бұрын
Not necessary, no. The position wont change after replacing the ball joint. You do however when replacing bearings/hubs etc. Greg
Excellent video, just found both worn by mot guy 😂
@ORileysAutos
Жыл бұрын
Oh no!
@DaveGreeneramblingcarpenter
Жыл бұрын
@@ORileysAutos 😂😂 thought id done well getting the traction control/steering angle sensor sorted
do you think I would have any chance of getting away with the drive shaft in its place without loosening the nut?
@jasperbarlow2582
9 ай бұрын
Couldn,t on mine, the hub needed to come out too far, you will need a 42 mm socket( preferably a strong impact type) as the nut is torqued really high.
@offshoretomorrow3346
7 ай бұрын
You could just jack the strut up to remove those bolts, I believe.
I imagine those are prelubed for life?
really annoying wind noise,
@samcabodi
2 жыл бұрын
really unhelpful comment,
@mikeholler514
2 жыл бұрын
@@samcabodi Why? Your content is worth criticizing. If it was crap, I would have ignored it. You have a talent worth polishing.