Bad MAP Sensor Signs: Don't Ignore These Engine Warnings

Автокөліктер мен көлік құралдары

In this informative video, we're delving into the world of your vehicle's MAP sensor and the crucial signs that it might be failing. The MAP (Manifold Absolute Pressure) sensor plays a pivotal role in your engine's performance, and detecting issues early can save you from costly repairs down the road. Join us as we discuss the symptoms of a bad MAP sensor, their impact on your vehicle, and potential solutions. Don't forget to like, subscribe, and hit the notification bell for more automotive insights!
#mapsensor #BadMAPSensor #enginetroubleshooting #vehiclemaintenance #automotivetips #MAPSensorProblems #carmaintenance #engineperformance #carrepairs #SymptomsOfBadMAPSensor #MAPSensorFailure #engineissues #EngineWarning #automaintenance #MAPSensorDiagnosis #carcare #VehicleSensors #engineproblems #checkenginelight #cardiagnostics #AutomotiveHowTo
Source: bityl.co/LLzW

Пікірлер: 8

  • @frias2287
    @frias228710 ай бұрын

    Good job🤝💯🔥💪👍

  • @studentlesson

    @studentlesson

    10 ай бұрын

    Thanks 🔥

  • @anthonyjacksonjr4812
    @anthonyjacksonjr4812Ай бұрын

    👍🏾👍🏾👍🏾🔥🔥🔥

  • @byrdworldbands6791
    @byrdworldbands679126 күн бұрын

    🔥

  • @Joeo-qk2du
    @Joeo-qk2du6 ай бұрын

    Damm Rick and his air fuel mix. Knock it off Rick dmmmit 😂

  • @timguy161
    @timguy1617 ай бұрын

    My Honda J-series engine (2007 V6) has rough idle and sometimes misfire DTC. I noticed that the idling engine "Intake manifold absolute pressure" is around 27 kPa. During normal highway driving at constant speed, I see fast fluctuations without reason (going up to 75 kPa or 85 kPa for a fraction of a section and then drop to around 27 kPa). When engine is not not running, I get 100 kPa (close to 1 atm), My LTFT is +14% or sometimes +20%. Is my MAP sensor bad? If so, why do I get 100 kPa and 27 kPa which are considered normal for non-running engine and idling engine? Overall fuel economy is around 20 mpg on par with similar cars. I hope someone can shed a light on this. Thanks.

  • @whitejodeci8926
    @whitejodeci89264 ай бұрын

    I juat changed mine, do you need to drove a few miles for it to adjust?

  • @whlawson5812
    @whlawson58129 ай бұрын

    Below are the approx math figures of MAF values, for my 1.8 litre supercharge engine, running at manifold pressure at 0 psi. 3000rpm = 41 g/sec, 2500rpm = 34g/second, 2000rpm = 27g/second, 1500rpm = 20g/second. These MAF values can increase by 1.5 times when supercharger kick in an ramps up manifold pressure to 8psi. These figures is on a sticker which I place on the dashboard for occasional quick check when I put the car on auto cruise mode to required rpm. Whenever the manifold pressure is within -0.5 to +0.5psi the MAF readout given out by OBD2 matches closely with these value value. The on-the-dashboard mounted OBD2 could could also show throttle body position, IAF, injection advance, short or long fuel trim, etc etc. At hot engine idling rpm of 750, without air conditioner switch on, on P position, the MAF is about 4.5 to 4.7g/second vs throttle body at 14.9% open vs MAP at -7.3psi. This value is useful if there is a partial vacuum leak or MAF is dirty etc etc. BTW, to me, this video is really not deep enough for it to be really useful to anyone.

Келесі