बाइक के इंजन में ओवरहीटिंग क्यों होता हैं? | Engine Overheating - Causes and Ways to Prevent it
To prevent a motorcycle engine from overheating, you will need to keep up with basic maintenance of the motorcycle such as regular oil changes and having proper coolant levels (for water cooled motorcycles). Make sure the idle screw on the carburetor is at a decent spot so the motorcycle does not maintain a high idle.
Air cooled vs Oil cooled vs Liquid cooled - Which engine is the best? : • Air cooled vs Oil cool...
How many km should a motorcycle run continuously? : • मोटरसाइकिल को लगातार क...
What are Engine Oil Grades : • What are Engine Oil Gr...
How often to change Engine Oil in Motorcycle? : • How often to change En...
CAUSES AND WAYS TO PREVENT IT
Initial start: When you crank up your motorcycle to leave for work everyday, please do not over rev the motorcycle as soon as you start it. Keep the engine at idle for a few minutes and let the engine oil do its job. This process is called engine warm up and doing this will keep your motorcycle’s engine healthy.
Carburetor setting: The mixture of air and fuel entering the engine cylinder must be correct in order to overcome overheating of the motorcycle. If air/fuel mixture entering the engine is lean then there are chances of your engine overheating. So setting the carb to give a perfect mixture is really important.
Engine oil check: Always keep your engine oil at check to overcome engine overheating. Low engine oil will lead to inadequate cooling of the engine. Engine oil must be changed at correct intervals for a healthy engine life.
Coolant check: Liquid cooled motorcycles come with a radiator setup which circulates the coolant inside the engine to cool the engine effectively. Proper coolant capacity and a perfect mix of the coolant with distilled water makes way for efficient cooling.
Faulty radiators and radiator fan: Radiator is a part which circulates coolant into the engine. The coolant when circulated, carries all the heat. If the radiator is covered with dust and waste particles, the heat dissipation will not be complete and the coolant will not cool enough to enter the engine again. Keeping the fins of the radiator clean is a very important part to aid for better cooling.
Radiator fans are used to cool down the coolant in the radiator when the motorcycle is stand still and the coolant temperature exceeds. Improper functioning of the fan leads to consequences.
Coolant leak: Make sure the coolant level is correct at all times. If the level of coolant is below the recommended level, immediately top it up by adding distilled water to avoid heating problems. Fix the leak, if any and continue riding.
Riding at high speeds for a long time: Riding at high speeds for a long time means keeping the engine revving high. Revving the engine high for a long time will keep the pistons moving and the combustion of fuel takes place without a break. Its best to stop the engine and let it cool for about 10-15 minutes and carry on while taking break intervals thereafter.
#EngineOverheating #Motorcycle #Safety
Join my channel and become a member : / @mechanicaltechhindi
The wait is finally over. I am here with KZread's very first Automobile & Mechanical Engineering Channel in HINDI.
In this channel i will upload videos related to automobile and mechanical engineering topics such as engine, I C engine, Cars, Motorcycles, Production, HMT, Thermodynamics, FM, CAD/CAM etc.
So subscribe my channel and learn everyday
Follow me on twitter: ⤵
/ dashingdanish11
Add me on Facebook: ⤵
/ danish.ali.754
Follow channel on Instagram: ⤵ / mechanicaltechhindi
Contact me: ⤵
mechanicaltechhindi@gmail.com
Пікірлер: 821
10000%%%% CORRECT V YSEFULL POINTS YOU COVERD
You're a gift to everyone you meet. Motivated and hardworking.
@MECHANICALTECHHINDI
3 жыл бұрын
😊👍
Very useful information Thank you Sir
Your video and it's content is far better than thumbnail
Jabardast information about engine heating 👌👌👌
I have a splendor+ bike , which has covered nearly 87000 KM and have show room look , I follow all those rules which u discuss , thanks for giving these tips .
Whether engine overheatng could be caused by thinning of oil density also?
Your videos are very helpful for mechanical students.I have learnt a lot from you which I have not learn from my college also. you are doing a tremendous job for us who belong to a very poor class family. Thanks a lot Sir . god bless you always🙏🙏🙏
Wow superb information thank you Sir...
Omg sir very nice knowlage thanks very helpful ❤️💕❤️💓💕
Maine jaisa socha tha jesa apply bhi karta hu bilkul sahi bataya appne Tysm
Sir you are right, but as per my knowledge oil need to be completely changed, after some km riding of the byke, oil looses its ability to absorb heat from the engine and reject to the atmosphere so oil needs to be completely changed.
Great information sir, thanks 🙏🙏
Hi Very good and genuine knowledge shared by you. I recommend your channel . Can you please tell me At what RPM, gears should be changed during up shifting and down shifting..? And does RPM increases with increase in speed? I have Yamaha MT15 bike.
Another reason for the engine to overheat is that if you set the taapet clearance setting properly, the engine will run very smoothly.
Thanku sir for your information 🙂👍
Is tarah ka video plz banate rahe sir... vehicle problems and their solutions...plz sir...isse naye students ko bohot help milegi
@MECHANICALTECHHINDI
3 жыл бұрын
😊👍👍
Very informative video 👍
Bahut shandaar tarike se aap humko samjhadiye Thank you Sir
My bike recommendation 10w30, but itll cause many problems. So i top up 20w40. Then getting smooth riding. Will it ok?
AWESOME VIDEO SIR 💜
Ek no. Information diya , bhai Saab. Bhot bhot dhanyawaad🙏 thank you very much. Aise hi Vidya badatein chale. 1 million subscribers aapke channel Ko.
@MECHANICALTECHHINDI
3 жыл бұрын
😊👍👍👍
Thanks 4 good knowledge
thanks a lot for information
बहुत ही बडीया इन्फॉर्मेशन दि धन्यवाद मेरे दोस्त
@MECHANICALTECHHINDI
3 жыл бұрын
😊👍👍👍
First time I searched.. I m facing nd finally I got right answer by A Right PersoN 🙏Thank you Sr..😊
Thanks for the Video
Thanks DaDa Very Useful Video
@MECHANICALTECHHINDI
3 жыл бұрын
👍👍👍
Good information
Most important your information I like it
Nice information सर thanks
sr very useful vedio thanks
Bahut achi jaankari
Nice explanation Sir 👍 Plz tell us for car also
Very informative
Thanx a lot sir Good information provided by you
Awesome 👍 sandaar 👌
Thank you sir
sir with respect I would to ask you one question, does changing ordinary engine oil to fully synthetic oil helps in heating issues?
Very good & useful information.
@MECHANICALTECHHINDI
3 жыл бұрын
👍👍👍
Tysm good informative sir
Nice knowledge diliverd by u danish Bhai😊😊😊🙃🙃🙃🙃
@MECHANICALTECHHINDI
3 жыл бұрын
😊👍👍
Useful info thank u sir
Good explain
Thank you 🙏
You are right... Awesome ji
@MECHANICALTECHHINDI
3 жыл бұрын
😊👍👍
thankou for information sir
@MECHANICALTECHHINDI
3 жыл бұрын
Welcome
Sir your manner and technique of explanation shows your love for the subject and in depth knowledge. If I had got a teacher like you who calmly and patiently explained everything in a very simple manner I would have been a different person altogether and would have achieved great success in my life. Anyways lots of love to you 💖🙏🙏
@MECHANICALTECHHINDI
3 жыл бұрын
Thanks 😊👍
@shakiransarishakiransari3263
2 жыл бұрын
बाइक के रेगुलर कितने किलोमीटर
Very helpful 👍 sir
Plz share CC wise riding schedule
Thank you sir.
Nyc knowledge bro
Respected Sir, why the CDI coil is getting extra hot
Jabardast vedio suggest best engine oil for Passion pro
बहुत अच्छा भाईसाहब धन्यवाद
@MECHANICALTECHHINDI
3 жыл бұрын
👍👍👍
Very good information bro 👍🏽🤟
@MECHANICALTECHHINDI
3 жыл бұрын
👍👍👍
Bahut hi achchha laga video sir ji bus aesa hi video banate rhe
@MECHANICALTECHHINDI
3 жыл бұрын
👍👍👍
Bro.. kindly tell me , I have avenger 220 cruise, engine heating and oil burning smell issue raised last 10 days
Sir bahut achi jankari hai apki
Good information.
Thank you sir god bless you
@MECHANICALTECHHINDI
3 жыл бұрын
👍👍👍
Thank you sir... it's very helpful information.. it's because of your guidance and instructions I have driven my Activa 5g from Delhi to GORAKHPUR...approx 953km and my scooty is in good condition.. again.. Thank you so much :)
@MECHANICALTECHHINDI
3 жыл бұрын
U r most welcome 😊👍
@ganeshbharadwajshooter1913
3 жыл бұрын
How many days u took? Fantastic job
@PawanKumar-im1ru
3 жыл бұрын
@@ganeshbharadwajshooter1913 bro..it took 28hrs... since it was new scooty..so I have to take breaks after 70-80km and the long halt was at Lucknow for 4hrs
sir kya car ka coolnet per also distilled water use karna chahiye?
Very informative video bro
Thank you sir very informative video Kya aapki bhi workshop h
Very good sir
what if I pour engine oil more than necessary. how to reduce engine oil?
Very nice knowledge
@MECHANICALTECHHINDI
3 жыл бұрын
👍👍👍
So much knowledge butt still people think mechanical engineering is not good
Nice job sir ji 👍👍👍
Good thanks
Can you please suggest possible reasons?
Good information sir 👍🏻
@MECHANICALTECHHINDI
3 жыл бұрын
👍👍
Nice information..., dear have u any Yamaha rx 100...old one..
Apka style accha hein hello friends welcome to mechanical tech hindi with upwards two hands 👌😃
Nice information sir
Good knowledge
Thanks sir 🙏
Sir Pulsar 150 Me Twin Head sparg plug Laga Sakte Hi ...Dono Side
Sir plz make a video on how to set mileage in Apache RTR 160 2V
i feel another possible reason behind engine being over-heated is riding your bike roughly in a careless manner with the frequent variation in speed and acceleration.
@zuber_rao
Жыл бұрын
100%agree😅😅
@gyanprakashgoutamknowladeg5831
2 ай бұрын
😊
Very Nice Explained 👍
@MECHANICALTECHHINDI
3 жыл бұрын
👍👍👍
Use full ❣️
Give tips for change Tyre. how many km Tyre change?
Well explained
Sir which engine oil is best for TV's victor
thanks sire
Nice information
thank you sir ji.
Thanks sir ji
Bahar achha sir. Thank 🙏you
Thanks ❤❤❤
Best information
@MECHANICALTECHHINDI
3 жыл бұрын
👍👍👍
Most of the time I miss your video because of thumbnail But I see by searching your channel
@MECHANICALTECHHINDI
3 жыл бұрын
Okay
Thank usable video
@MECHANICALTECHHINDI
3 жыл бұрын
👍👍👍
Bahot badhiya bhaiji
Best Chanel
Nice explation ❤️❤️❤️❤️❤️❤️
@MECHANICALTECHHINDI
3 жыл бұрын
👍
Nice information bro thanks
@MECHANICALTECHHINDI
3 жыл бұрын
Welcome
Nice sir