I just did that yesterday did not remove the axils, used a cut off wheel cut the top of the axils about a third of the diameter of the pipe. Froor jacked them up 5/8" checked Camber, welded up cut. Let cool with Jack still holding pressure. Worked perfect🎉

Best method I've seen so far,my small trailer badly bent ,there is hope for it ,I got 6 ton jack stands ,got lots of chains,need to get I- beam or railroad tie

Thanks for the share! I used a railroad tie, worked like a charm. Keep rocking brother

Yup, this is what I need to do to my snowmobile trailer :). Thanks for the video.

good vid thanks for posting ! ... Cheers

thanks for the info. my boat trailer axle is sagging

Good stuff. MAN STUFF !

Like what you did very helpful to me

Great video New subscriber Cheers

Nice !!...the axle im having issues with is quite a bit different...its and axle out of an atv ..solid pretty standard but bent pretty bad! Question: can I do the same kinda metal bending like your video except with atv axle and steel pipes that fit snug over both axle ends to extend width for more leverage and control in bending back straight ? It's bent down one one side and up on the other unlike your axle that waz over grossed.. hmm I'm rethinking this now ..this atv I bought dirt cheap because it fell off top of truck on the freeway at 60mph and bent the rear axle and broke the fender plastic ....I'm worried it will break before it gives again?? Any thoughts or ideas any body ...( I could purchase a new axle but what fun is that?) Thanx!!

Lol. All u need is an Ibeam. Nice work tho

Buy a bigger axle or maybe truss the axle so it doesn't bend so easy .

I was thinking something similar for fixing my go kart

hahah he said "J**k**f".... :-p