Audi S4 B8.5 Single Turbo conversion part 1 “ build turbo manifold “

Автокөліктер мен көлік құралдары

This is short video of turbo manifold and some tips for you if you are planing to do something similar and by this videos you can see what needs to be done. This is part 1 set a turbo at location where we need it and build custom manifold. Part 2 will with the car already we have to install our turbo with manifold and continue fabrication of turbo downpipe and wastegate line. Stay tuned!

Пікірлер: 42

  • @guillaume8464
    @guillaume8464 Жыл бұрын

    Hello, the project is interesting, where is the part 2 and 3 and 4 and test drive ? :O

  • @davidmusiyenko4158
    @davidmusiyenko41583 жыл бұрын

    Yessss!!!!

  • @phantomflame0658
    @phantomflame065810 ай бұрын

    What is the function of the little flex pipe in this application? If you're solid mounting the turbo to the engine/trans then what's the point? Otherwise sick build

  • @spanner5046
    @spanner50462 жыл бұрын

    Hi there, are you able too sleeve a 3.0 TFSI? I've got a scored bore, having the throw away the engine unless i could get it sleeved.

  • @1brx
    @1brx2 ай бұрын

    I would also like a kit

  • @MangoMotorsportsLLC
    @MangoMotorsportsLLC2 жыл бұрын

    What did u do for intake manifold

  • @kassanova5430
    @kassanova54309 ай бұрын

    Did you keep stock exhaust manifolds or custom turbo manifolds. I couldn’t see it from the angles you only showed back of motor.

  • @benwan5425
    @benwan54252 жыл бұрын

    So did you just gut the supercharger to use as a manifold

  • @carlosguzman9356
    @carlosguzman9356 Жыл бұрын

    Where do you run the oil line to the turbo

  • @WillieWheels
    @WillieWheels3 жыл бұрын

    Hey what’s your 1/4mile and 0-60 times?

  • @QuikModsOBS
    @QuikModsOBS2 жыл бұрын

    Selling kits?

  • @Jerrycg
    @Jerrycg3 жыл бұрын

    Im about to do a similar build but with 2 small turbos, low psi. What is your thoughts on this? Im wondering how the engine will react with such flow early in the revs.

  • @Svarogperformance

    @Svarogperformance

    3 жыл бұрын

    I don't like twins because of limited space and double more work fabrication plus all plumbing etc... Single turbo can be swapped in 30min and twins would take a lot longer also twins will create a lot more heat in engine bay. I'm not saying can't be done just too much work. 67mm turbo responds very well in my car and turbo in this video is new G35-900 should respond much quicker then my car

  • @Jerrycg

    @Jerrycg

    3 жыл бұрын

    @@Svarogperformance Sweet thanks, do you think you can swap for a medium size single on stock internals?

  • @Svarogperformance

    @Svarogperformance

    3 жыл бұрын

    @@Jerrycg my car got 67mm turbo and car in video is 62mm turbo it will respond a lot better then my car down low rpms and still able to make it over 600whp on this turbo

  • @Jerrycg

    @Jerrycg

    3 жыл бұрын

    @@Svarogperformance Its a late 2011 b8 by the way, i know they changed some stuff between b8-b8.5 hope engines are similar enough

  • @sashaghovanlou8175

    @sashaghovanlou8175

    2 жыл бұрын

    @@Jerrycg Why not just keep the supercharger? That's a lot of work for baby power no?

  • @fastboatster
    @fastboatster3 жыл бұрын

    What happened to the trans, why’s only half attached to the engine?)

  • @Svarogperformance

    @Svarogperformance

    3 жыл бұрын

    Trany dead and engine dead only good for fab work 😚

  • @fastboatster

    @fastboatster

    3 жыл бұрын

    @@Svarogperformance so they are like fixtures

  • @samsonvang9232
    @samsonvang9232 Жыл бұрын

    What happened to this build?

  • @jamiemichels7248
    @jamiemichels7248 Жыл бұрын

    I didn't watch the whole video lol but are you keeping the super charger?

  • @Svarogperformance

    @Svarogperformance

    Жыл бұрын

    yes

  • @filmssdv
    @filmssdv3 жыл бұрын

    Сколько лошадей планируешь снять и какой крутящий момент будет ?

  • @Svarogperformance

    @Svarogperformance

    3 жыл бұрын

    Примерно 700л и 850Nm ... Стенд будет что бы подтвердить эти цифры

  • @filmssdv

    @filmssdv

    3 жыл бұрын

    @@Svarogperformance Кватро выдерживает такой крутящий момент ? Там ничего дорабатывать не надо ?

  • @Svarogperformance

    @Svarogperformance

    3 жыл бұрын

    @@filmssdv хорошая настройка на DSG

  • @filmssdv

    @filmssdv

    3 жыл бұрын

    @@Svarogperformance какая фирма чип тюнинга на твой взгляд лучше остальных ?

  • @Svarogperformance

    @Svarogperformance

    3 жыл бұрын

    @@filmssdv если ты про 3.0 компрессор тогда 034

  • @carlosguzman9356
    @carlosguzman9356 Жыл бұрын

    Are you selling kits and would it fit the same on a S4

  • @Svarogperformance

    @Svarogperformance

    Жыл бұрын

    Hi , only taking as project i have one unfished kit i need a car to finish and install

  • @carlosguzman9356

    @carlosguzman9356

    Жыл бұрын

    @@Svarogperformance if you start selling kits I’m interested

  • @TrelloACNF

    @TrelloACNF

    Жыл бұрын

    Same

  • @garretsimmons9024

    @garretsimmons9024

    7 ай бұрын

    @@Svarogperformanceuse my car?

  • @Tatito102
    @Tatito102 Жыл бұрын

    How much to make me one For my 2009 A5 3.2????

  • @Svarogperformance

    @Svarogperformance

    Жыл бұрын

    $8k + the pend of hardware

  • @alvislukins7827
    @alvislukins78273 жыл бұрын

    What is the expected crank power with stock internals?

  • @Svarogperformance

    @Svarogperformance

    3 жыл бұрын

    700hp

  • @alvislukins7827

    @alvislukins7827

    3 жыл бұрын

    @@Svarogperformance pretty decent amount for stock engine. Believe that reliabilty become an issue. But anyway nice project. I also have an s4...good car but eat some money 🤪 How is going on with v8 swap to another s4?

  • @Svarogperformance

    @Svarogperformance

    3 жыл бұрын

    @@alvislukins7827 Not really, the most issues were for me transmission but now we finger out after 4 years to finally make DSG happy.

  • @FourRingsShinyThings

    @FourRingsShinyThings

    3 жыл бұрын

    Looks great so far. Looking forward to the updates 👀

Келесі