I knew this was you by your voice. I was looking at videos and I recognized your voice. I came by and test drove your white Audi A4 a few months ago.

@strictlyaudis7012

2 жыл бұрын

That car was amazing , I just sold it . Yeah I remember you and thanks for joining the community

Great job, keep up the awesome job. I became a subscriber after watching this video.

mine Q5 2013 going into limpmode on highway only slightly uphill. N75 was changed as well as intercooler but the problem po299 underboost ist still there. Kn the citty there is no problems no matter how you drive it only ln a highway 120-130km/h and uphill goes into limp mode. Can you help???

Hello Naptowntuner, Would you be interested to show, review and promote our new turbobend tool? The new tool is a novel way to fix the loose turbo wastgate issue for the Audi/ VW 2.0 TSI engines.

i have a 2004 audi a4 v6 my raditor fans dont turn on at all and my ac does not blow cold air. when i take out the 10 amp ac fuse my fans run all the time. how to i fix this please let me kwno

Hi, the actuator for my wastegate is not holding pressure. The wastegate flapper is shut closed. But the actuator rod does move and open the wastegate when I applied pressure to the actuator. The flapper has no play and sits tight. Can a stucked CLOSED wastegate flapper cause P0299 code. I am getting a P0299 with closed wastegate flapper. Is this possible? Any help would be greatly appreciated. Thank you.

How do I get access to the engine to remove and replace the part ? What is the name of the part?

I have the same car when I scan it it say the booster vale and camshaft faulty but I’m not hundred percent if that’s really the problem

I want to see how you extract that exhaust stud. Or if you just bolt it back up without it. If it wasnt leaking from the manifold before I would say bolt it up without it.

@strictlyaudis7012

3 жыл бұрын

Thank you so much , I will extract that bolt and upload a vedio

@deisyperez6297

Жыл бұрын

​@@strictlyaudis7012 did you take it off

@strictlyaudis7012

Жыл бұрын

@@deisyperez6297 i tried myself to take it , I ended up drilling the bolt , I tapped it and used a small bolt inside that bolt till I took off the cylinder head to the machine shop later and they removed it for me

you did 'not have to buy a new turbo, only the wastegate valve had to be adjusted so that it seals the wastegate

How Kilometer have you?

@strictlyaudis7012

Жыл бұрын

172 k miles , 172000 x 1.6