Attempting to start the engine with new fuel pump

Пікірлер: 8

  • @joshdye1684
    @joshdye168414 күн бұрын

    I have to run those AVS2 carbs at just about one turn open only on your air fuel! They seem to flood bad.

  • @RedneckMechanicTurningWrenches

    @RedneckMechanicTurningWrenches

    14 күн бұрын

    @@joshdye1684 I’ll give this a try thank you for the tips

  • @joshdye1684

    @joshdye1684

    14 күн бұрын

    @@RedneckMechanicTurningWrenches absolutely! I several of the exact same set ups, and have fought the exact same issues. Adjust your throttle screw down, and choke down your air fuel

  • @josephadams7106
    @josephadams710616 күн бұрын

    Pour a little fuel down the carb and try to start it. Sometimes, when you change the fuel pump, you need to prime it. This is how you do it. Cranking rpm may not be enough to get the fuel up to the carb. Was the timing off before you changed the pump?!

  • @RedneckMechanicTurningWrenches

    @RedneckMechanicTurningWrenches

    16 күн бұрын

    @@josephadams7106 No the timing should be close. I’ll have to use my timing light once it gets started though

  • @RedneckMechanicTurningWrenches

    @RedneckMechanicTurningWrenches

    14 күн бұрын

    @@josephadams7106 I just reread your comment and I’ll try adding fuel to prime the pump this time

  • @joshdye1684
    @joshdye168414 күн бұрын

    Is your vacuum advance on your carb plugged off? Could be a vacuum leak. Or try unplugging your electric choke

  • @RedneckMechanicTurningWrenches

    @RedneckMechanicTurningWrenches

    14 күн бұрын

    @@joshdye1684 if adding fuel to the carb don’t work I’ll try this to see if the electric choke is working