Assembling the Hull Panels on a Stitch and Glue Kayak - Petrel Play SG Build - E4.1
Тәжірибелік нұсқаулар және стиль
Bill and I put the hull panels together on the Petrel Play SG kayak design from a kit by Chesapeake Light Craft (CLCBoats.com) bit.ly/3uRnqzA.
In this series we will take you through a step-by-step process of converting a pile of wood bits in to a beautiful, functional kayak
Petrel Play SG Plans: guillemot-kayaks.com/catalog/...
Petrel Play SG Kit at @CLCBoats1 : bit.ly/46LoS3O
The Mohawk Stain used is available at CLCBoats.com: bit.ly/3Nfu9d0
Support my Patreon to Help Produce More Videos: / nickschade
0:00 Paddling the Petrel Sport
0:20 Introduction
0:40 Identifying Parts
4:14 Fitting the Bottom Puzzle Joints
5:39 Using CyanoAcrylate (CA) Glue
7:26 Spot Welding Puzzle Joints
17:55 Assembling Side Panels
23:05 Discussion
24:17 Outro
27:10 Next Episode Preview
Пікірлер: 8
Id gladly watch a 1.5 hour video of this. I’d sit easily for a couple hours and watch
@mikeisland7382
7 ай бұрын
It's like Christmas came early.
I could watch your videos for a whole day, you are doing a great job. Thank you
👍 Lookin good.
Been following your channel for some time now. Really enjoy watching this series. Keep up the great work. Thanks for sharing.
@NickSchade
7 ай бұрын
Awesome, thank you!
Why not use a thinner CA glue which would really wick into the joint?
@NickSchade
7 ай бұрын
That may work, but some CA glue is so thin it does not bridge any gap, and it can run straight through and make a drip on the other side.