Arrma Kraton 6s EXB RTR v2 Bash!(uh oh!)
I bent the driveshaft at some point during the bash, and eventually, it managed to pop itself out. It's not too big of a deal, I've bent plenty back straight in the past. Since I had replacements ready, I opted to swap it out and keep the old one for a quick switch while out in the future. I should probably consider upgrading to M2C shafts with how hard I bash 😅
#arrma #rc #rccar #canada #fun #beastmode #hobby #rcbashing #usa #bigair #brushless
Пікірлер: 9
Dang ol drive shaft popped oot😊
Cool truck 🚒
Nice dude 👌
@CanadianRC96
Ай бұрын
Thanks!! I really appreciate the support 😊
@CanadianRC96
Ай бұрын
I just subbed you 👍
You drive her nice. Made me want to get mine out, especially if I could get a session like that. I've popped too many drive shafts. What else have you broken on her? Any upgrades or modifications?
@CanadianRC96
Ай бұрын
Thank you! I really appreciate the support! I've broken 3 rear arms and the front arm. Bent a couple front driveshafts. Usually the slight bend is what makes them pop(assuming proper droop adjustment) also broke a wing on a fluke chassis slap, wing on it now has actually been landed on and is fine 🤷♂️ the arms are completely my fault, 2 are on the page and 1 bad landing I had off camera I broke both rears. I'm planning on m2c driveshafts in the front for sure. The rest is solid so far 👍👌 oh I ripped a tire on the edge of the ramp 😅
@bluebeastRC
Ай бұрын
@@CanadianRC96 Sounds like my list. 😂 The M2C driveshafts are definitely beefier. Though I did snap the pin off of one of them. I've also broken many of the drive shaft out cups. Get the M2C out drive cups as well.
@CanadianRC96
Ай бұрын
@bluebeastRC I'm pretty sure those pins are replaceable on the m2c shafts. Saves buying new ones. I chewed up a cup, but it's still going lol