Before installing the motor you have to solder the wires. Now, how to solder the wires based on polarity??..... I have an idea. These motors already have a set of screws which connects the yellow casing. When you look at those screwa in such a way that the motor is on your left side and the shaft is on your right, then most probably the top terminal is GND and the bottom is +. This is from my experience.

@technologyguide5

10 ай бұрын

you are right.. solder before installation but on other side terminals we may change if the rotation of direction changes

Wow 😯 nice video 🥰

@technologyguide5

3 жыл бұрын

Thankq

Where is the slot for connecting aurdino and bluetooth receiver

@technologyguide5

7 ай бұрын

I will do another video

Thanks

@technologyguide5

9 ай бұрын

Welcome

Nice 👌

@technologyguide5

3 жыл бұрын

Thanks 😊

can you please provide the size of the chasis

@technologyguide5

5 ай бұрын

check it amzn.to/3UxEXI0

Total rs?

Nice^_^

@technologyguide5

3 жыл бұрын

thanks

how do you control the motors here with the arduino. don't you have to connect wires to them?

@technologyguide5

Жыл бұрын

You are right but I couldn't do series videos ...

What is size of battery ??

@havertzs_balls

8 ай бұрын

AA, 1.5 volts, or just use the power from an arduino which is 5v since the batteries are 6 volts

@technologyguide5

8 ай бұрын

18650 batteries needed