Great video!!!

@Blowncapacitor84

9 ай бұрын

Thank you!!

Too cool! Thanks!

@Blowncapacitor84

8 ай бұрын

Anytime!

Been tinkering with these boxes for a while if the woofer dies go snag a Rockford fosgate R2D4 10" prime woofer 4ohm they are a direct drop in and work with the amp and can handle more power than the built in amp also if you wanna port using the 10" fosgate woofer you can use a single 2" 7" long port on the right side of the woofer across from the amp this will improve it a good amount i have 3 all wired on a 2 ohm load so the amps get a bit hotter but after 2 years of daily abuse and what not in the minitruck no issues from anything i did use 8 gauge wiring for all of the boxes.

@Blowncapacitor84

4 ай бұрын

That's AWESOME!! thank you for the tips!!

NS here!!! I like you!!!

@Blowncapacitor84

9 ай бұрын

Thank you!!! I like you too!!!

Thanks

@Blowncapacitor84

4 ай бұрын

You're welcome!

just hooked mine up and tapped into the rear speakers. Sounds great, but my question is; Is it normal for the side aluminum panel to run real hot to the touch? And if not, what can I do to help cool it from running hot if there is anything to do?

@Blowncapacitor84

5 ай бұрын

It will get warm, but it shouldn't get hot. It may help if you turn the Input volume down a little bit because i think the heatsink (that aluminum panel) is too small for the amplifier (which sucks lol) also if it's covered in some way it can overheat. I guess let it go and see if it goes into protect mode or starts cutting out. If it gets hot to where you can't comfortably keep your finger on it then it may just be defective.

Thats a nice burn you got there done that before 😢

@Blowncapacitor84

9 ай бұрын

Yeah, it a doozy! Ouch!

@Blowncapacitor84

9 ай бұрын

Lol it was one of those that I could hear😂

I have no choice but to lay it down. It’s going into protect mode due to the heat not being able to escape. Would drilling a 1 or 2 inch hole above the heat sink allow for heat to escape better?

@Blowncapacitor84

6 ай бұрын

Man that sucks. It might just be broke. I don't think drilling a hole will help much but worth a try.

Can I see a picture of the tune you have on the amp plz mine gets to hot and turns off

@Blowncapacitor84

Ай бұрын

If the subwoorer output voltage from your headunit is different it won't help. What head unit are you using?

I wonder what around 10 of these would sound like, lol.

@Blowncapacitor84

29 күн бұрын

I'd imagine it would be pretty loud for sure! I turned up the one in the wife's car and it bumps pretty good so times that by ten and it would probably be crazy!

How would it sound if I hooked the rca straight to a door speaker?

@Blowncapacitor84

5 ай бұрын

Nothing. Rca's are line level, which means there's not enough power to drive the speaker.

@user-kc9nz3fv4e

5 ай бұрын

@@Blowncapacitor84 nah man old school. RCA’s hooked into amp( same setup in vid) and the head unit side just cut the jacks off and connect wires straight to existing speaker/ speaker wire

Nice video...so I'm missing the connector so wondering if you can refresh me on wiring high level? Oh also, I see you didn't use both remote wires. Why is that and why is there 2 if not needed?

@Blowncapacitor84

6 ай бұрын

There is no high-level input, unfortunately. But you can order a new harness online. As far as the remote or any of the wires from the harness, you only have to use one from each. They put two wires going to each pin so you can daisy chain them.

@nathanheynen3576

6 ай бұрын

@Blowncapacitor84 actually had a chance to do some reading..I guess everything is high level(speaker level) until rca come into play converting it to low level. So I'm going to soder to the pins and it said if using high level connections, I won't need to worry about the remote wire period as it supposedly gets the "turn on" from the speaker connection. I'm probably wrong but I'm going in

@Blowncapacitor84

6 ай бұрын

@@nathanheynen3576 Nice!!!

That was a great video but what I want to know is how would I hook that up to the car battery in my garage without a receiver or car amp kit, just from my independent home stereo speakers and car sub I have hooked up to a Bluetooth portable speaker. Will I have problems with the fuses blowing out or the actual Dual sub with amp being damaged. This will help me out a lot if you can reply back thank you and the video was very helpful.

@Blowncapacitor84

5 ай бұрын

kzread.info/dash/bejne/e5ely5mLmbG9frA.htmlsi=ZHm9Xe5RefM4UXlt

@Blowncapacitor84

5 ай бұрын

I think this video should help out! Let me know if you're still having problems.👍

Hey so I bought this sub and swapped the speaker for a marine grade " Polk DB1042" had it running off the battery hooked up to my boat stereo. Went to install it under the seat, same wiring configuration and now the power LED won't turn on. What went wrong? Speaker too powerful for amp? Thanks!

@Blowncapacitor84

14 сағат бұрын

@@user-ik6dh7gj5c that's a good one... did you ever power it up prior to changing the speaker?

@user-ik6dh7gj5c

24 минут бұрын

All good, got it sorted out - she sounds great!

@Blowncapacitor84

21 минут бұрын

@@user-ik6dh7gj5c Nice! Enjoy!

Can I connect an additional amp to a preamp subwoofer like this

@Blowncapacitor84

24 күн бұрын

Yes. Use rca splitters

@82richies

24 күн бұрын

How would i do that and thank you for getting back to me ​@Blowncapacitor84

Can you hook two of them together the the dual 10-inch amplifier inside deals I got two of them I don't know how to hook both of them together and it is 416

@Blowncapacitor84

5 ай бұрын

Run the positive wire from the battery to one of the red wires on the harness of the first one. Then, run a wire from the other wire on the first harness to the second harness. You should fuse that wire running from one to the other. You can also do the same thing for the ground and remote too.

@Blowncapacitor84

5 ай бұрын

But you don't have to fuse the remote or ground... they're kinda designed to run more than one! Hope that helps!

Does it sound good with the Yamaha receiver?

@Blowncapacitor84

9 ай бұрын

Yes it does!!! I think I'm gonna keep it there!

Is it possible to tie a second one into the 1st? (daisy chain it)

@Blowncapacitor84

4 ай бұрын

Absolutely! That's why there are 2 power, ground, and remote wires. They connect in the amp and are bridged. Just grab some rca splitters.

@williammcgrath1709

4 ай бұрын

Awesome thanks!@@Blowncapacitor84

@Blowncapacitor84

4 ай бұрын

@@williammcgrath1709 Absolutely no problem!

Can i blow a 1200w sub with a 400w amp?

@Blowncapacitor84

21 күн бұрын

Great question! Yes! Given that the "max" rating is for the sub (they lie) and 400w rms amp. If the amp is turned up too high, it sure can.

@Pac925

21 күн бұрын

@@Blowncapacitor84 Great thank you! Just got this powered sub. I cant tell if ill blow it because i cant use the meter to set lpf and gain. There are no ports to connect to only the small wire harness for power ground and remote.🤷‍♂️