oh exciting…still a bit nervous about using my herald, so will watch these carefully. I learnt so much important stuff watching your ‘put herald together’ vid. 😃👍🏻

@andrewhall6880

Жыл бұрын

Thanks Fiona I’m intending doing beginners projects that are short and make nice little give away gifts for family and friends that will help build confidence on the lathe Thats my plan, im enjoying getting all sorted with the lathe and planning the projects

@fionanaylor6104

Жыл бұрын

@@andrewhall6880 even more reasons to watch 😁(🙏request…indexing pls ? still no clue as to what, why and how 🤷‍♀️😂)

@andrewhall6880

Жыл бұрын

I will do a short tutorial Fiona thanks you for the request

Keen as ever & still buying lathes ! I'll watch out for the projects.

@andrewhall6880

Жыл бұрын

Cheers Ash I’m going back to how it all began starting with a tool handle

Hi Andrew. Question for you. The lowest speed on the coronet lathe is 250, is that low enough or do you think a low speed like on the powermatic would be better?

@andrewhall6880

7 ай бұрын

Hello Jack thanks for the question, it depends on what you want to do, if it’s thread chasing I find it fine for that with 20tpi chasers but if its for applying lacquer while the piece is rotating I would go for a lower speed lathe. I have a powermatic 3520B and both are great lathes but there’s a big difference in cost. No experience with a Powermatic smaller lathe but I’m sure if it anything like the 3520 it will be great engineering. Hope that helps