Insuperable reparacion,mejor que nuevo.

How did they know the proper way to connect the shaft to each other and what happens if they weld it together in the wrong position.

Доехать до следующего мастера вполне возможно ...и то если быстро дристануть с двух педалей то возможно и не доехать😂

Nice👍

I’m guessing this was a demonstration of ability rather than an actual fix. The bearing surface isn’t hardened and the oil hole he drilled is supposed to intersect with another hole to carry oil to that bearing. Impressive work nonetheless. I’m fascinated by the concept of a distributed machine shop, where one guy has a lathe, another has a mill, a third guy has a press, and each does their part.

@johnspathonis1078

2 ай бұрын

I thought the same thing but I think it is for real. Alignment is done by eye. The hole on centreline connects with the offset drilling at the ends. The stub he pressed in did not bottom out but left a small connecting end gap. He only had to drill to the centre hole and everything is reconnected. I think a hardened journal is the furtherist thing from their minds. As long as the crank works. The journal should not touch the bearing in 'theory' only protects against abrasion from contaminants in the lube oil. My major concern is how and where was the welder earthed? How did a steel crank like that break? Cheers

Nonsense that bearing will spin in just a few minutes. The supposed oil passage goes nowhere.

👌💯

Mantap 👍👍👍👍

For the love of god build a workbench already!

He use caliper the inside and out measurements.

а маслянный канал накой заглушили? В музей что ли колено готовили?

how can they live like this, open sewers!