Hummmph...Nobody ever shows using the old bearing to push the new one back in....Inspiring!!!...👏👏👏🥂🥂👍👍👍💰💰💰

I wondered what went into doing this. After watching, it's not hard to do but I would definately keep buying new alternators due to the amount of time it takes. And, I don't have a press, good video!

Well done! Thank you very much for your time and know how to make this video!😎👍

Use heat on the aluminum housing, and support the backside of the bearing housing my dude. Its very easy to deform or even crack the alternator case pounding it the bearing out like that.

@ZutiDIY

6 ай бұрын

Thanks for the tip

What make of bearing do you recommend? Excellent video by the way

This is such a great video. Thank you very much for your effort to show how to replace it. I have a question about the replacement. Can you tell my what are the bearing size and any website address i can get the bearing?

Thank you for demo

Great job

Perfect thanks

thank you

BEST VIDEO ON KZread!!!!!!!!!!

Why not replace the pulley while you're rebuilding. Thanks for the video, I'm learning!

@donald8354

Жыл бұрын

If the pulley is good why replace.

@Dassick89

9 ай бұрын

Because they cost the same as a whole alternator lol.

How to know a Pulley was good or bad ??can u explain it plz

@jesusp.7774

Жыл бұрын

The noise

I'm not sure if this alternator would work because at 10:04 he is using the inner race to drive in the outer race which causes damage to the bearing

@AwsBadr

11 ай бұрын

It will work. Would be better if he placed a metal piece to spread the pressure.

@benjaminzhou9503

7 ай бұрын

…. It seems to be a lady working on it, making the job even more admirable. Not sure though. The person was using the old bearing to drive in the new one. So didn’t need to worry about the old one getting ruined. I would put a thick piece of medal over it though, to push directly against the outer race on the new bearing’s outer race. Great video, very inspiring! Just need to make sure to use quality bearing, not all bearings are made equally well.

I wonder if I can do this without a press.

Where can I buy the bearings and what part numbers?

@ZutiDIY

9 ай бұрын

Ebay

I hope my Trabant 601 alternator is easier. I don't have a press

@constantinchivu583

3 ай бұрын

Greu fără presă

Good

I’d just purchase a new alternator..

@vr6swp

2 жыл бұрын

For my car, a rebuild kit with bearings, brushes and a new back cap is about $40 plus an afternoon’s work. New alternator is about $150-$200 plus core charge (and shipping both ways). You decide whats best for you

@stevenjosephs9

Жыл бұрын

Right , Remanufactured are crap ( shit )

@jesusp.7774

Жыл бұрын

And sometimes the aftermarkets are weaker on amps

Boss use gloves??????

@constantinchivu583

3 ай бұрын

Greu cu mănuși mai ales la lipituri colector și perii