Abaqus tutorials for beginners - Hollow Composite pipe Analysis
Ғылым және технология
This video shows how to create hollow composite pipe in abaqus,how to create composite and assign its properties in abaqus,meshing ,performing static analysis in abaqus.
OUR BLOG - trendingmechvideos.blogspot.com/
FOLLOW US ON FACEBOOK - / trendingmechvideos
▶️Watch Playlist below
▶️Abaqus Tutorials For Beginners
• Abaqus Tutorials For B...
▶️Abaqus Meshing Tutorials
• Abaqus Meshing Tutorials
▶️How to Plot Graphs in Abaqus
• Abaqus videos Ploting ...
▶️How to Perform Static linear analysis in Abaqus
• Abaqus tutorials-Stati...
▶️composite Material analysis and FE analysis
• abaqus composite analy...
▶️How to Perform Non-Linear Analysis in Abaqus
• Non Linear Analysis in...
▶️Abaqus Heat Transfer Tutorials for Beginners
• Abaqus Heat Transfer T...
▶️Basic Abaqus Tutorials for beginners
• Abaqus Basic Tutorial ...
▶️Buckling and Postbuckling Analaysis in Abaqus
• Abaqus Videos-Buckling...
▶️Useful Abaqus Tutorial Videos
• Useful Abaqus Tutorial...
▶️ANSYS TUTORIALS FOR BEGINNERS
• ANSYS TUTORIALS FOR BE...
Пікірлер: 10
Greeeaaaatttt thank you so much
thanks for your works and good luck in your life.
I'm not sure if the fiber orientation is right, the primary direction should be along the length (0deg)
how to create partion on shell then mesh?
Sir/Ma'am please make a step by step video on Friction Stir welding on Coupled Eulerian and Lagrangian approach in abaqus. Please there is no complete video on youtube. It will be a great help for mech community.Thankyou
How to do for stepped composite shaft? Can you help please?
How did you manage that S33 output is completely null? Thank you in advance
thank you, the video was really helpful to me. Where did you get the material properties from? I am currently facing a similar problem using carbon fibre laminate and I am missing G13 and G23. In the literature I found some formulas for G23 but the results I derived from them seem way too high. Also, is G12=G13 due to the orthotropy? Thanks in advance
Can you do a tutorial for concrete filled steel tube sections?
how can to assign the fibres property in abaqus?