well done lad, great vid

Thank you so much!

How i can show the crack of reinforced concrete under load pleases

Very helpful lesson, Thankyou sir.

@abaqusacumen7397

7 жыл бұрын

Thanks a lot for your support.

There is great content on Abaqus Simulation on Abaqus Acumen. Thanks a lot for posting these videos. Is it possible for you to arrange the content (videos) as per the subject/ domain/ advancement level in form of playlist? It will be helpful for Beginners who have just started learning Abaqus to follow it in a series. It's just a suggestion, Thanks a lot for your help and keep up the good work.

@abaqusacumen7397

7 жыл бұрын

Thanks a lot Prasad for your motivating words. You suggestion is valid, we need to be in proper sequence for the beginners.

Hi Sir Can we plot acceleration values versus frequency or displacement?

When I do data check for steady state dynamics in job manager I get this error: "PRESELECTED OUTPUT REQUESTS ARE IGNORED IN SIM-BASED MODAL SUPERPOSITION PROCEDURES (EXCEPT COMPLEX EIGENVALUE EXTRACTION). YOU MUST ALWAYS SPECIFY OUTPUT REQUESTS TO THE OUTPUT DATABASE (.ODB) FILE; OTHERWISE, THE ANALYSIS WILL NOT BE PERFORMED. A USER ODB OR SIM OUTPUT REQUEST IS REQUIRED IN A SIM-BASED PROCEDURE." Can anyone explain why?

How do we plot displacement vs time ?

When I data checked at 10:30 ,it shown aborted in status. Why? pls

THANKS SIR Can you please show me how to find a longitudinal natural frequency or axial vibration for beam (bar) in abaqus and how can i proceed

How did u get set 2, I only got set1, u did not defined sets right?

Bro I need help in fatigue analysis... Reply plz

Great video!! I'm not sure, but I don't think it is right to call the dip in the graph anti-resonance. If you increase (a lot) the "number of points" in the SDD step, that "anti-resonance" dip completely disapears

@tizianadirienzo5717

5 жыл бұрын

your comment is very helpful and clever, could I ask How to increase the number of points ??

@lucasmachado7389

4 жыл бұрын

Actually, it is showing only the real component of the results. To change it you can do [Result-->Options-->Complex Form->Magnitude]