That was a belter Tom, rather you than me snatching a cylinder that size. Chin up mate.

@PlumbLikeTom

9 ай бұрын

Thanks for the support as always mate, I took a chance as it was in a boiler room, the was only tepid at best as well, if it had been red hot there would be no way I would do it

Proper old school that heat exchanger and the coal lorry. Looks like it’s been a bit of a bodge. Proper 70’s bathroom suite.

@PlumbLikeTom

9 ай бұрын

A love a coloured bathroom suite, they will all be back in fashion soon, thanks for watching as always

You can measure to see if the immersion is knackered mate. Power off your looking for about 20 ohms or check for an earth leak. Great one as usual

@PlumbLikeTom

9 ай бұрын

I couldn't quite remember how to check them to be honest, this one was constantly tripping the RCD and was under warranty so I just changed it, thanks for watching as always 👍

Nice job with that snatch Tom, saved a load of time. Great vid as always mate

@PlumbLikeTom

9 ай бұрын

Thanks for the support as always mate, it would have took a good half hour to drain, I wouldn't recommend snatching them though

I expected a lot more water to come out of that cylinder when you snatched the immersion. I might try it One day 😂😂

@PlumbLikeTom

9 ай бұрын

They tend to hold back on an air lock, I wouldn't try it though in an house or if the water was hot, I also knew this would come out Ok being fairly new, sometimes a completely failed element will warp a bit making it hard to get out the hole, thanks for watching as always

First! Av it Tom. No one can plumb like...

@PlumbLikeTom

9 ай бұрын

Thanks for the support as always mate, it is greatly appreciated

You can't beat a good rip out Tom, nice job as always.

@PlumbLikeTom

9 ай бұрын

They are nice with the scrap, thanks for watching as always Keith

Nice team work there on the change over I did see the Slight step back as he knew the nut was coming on done😂 good video 👍👍👍👍👍

@PlumbLikeTom

9 ай бұрын

Thanks for the support as always mate, teamwork is dreamwork, sometimes it's nice to have a mate on jobs like these, shared responsibility when it all goes wrong 👍

No messing tom ....💪....quality work as always ....best plumbing chanel by far 👍

@PlumbLikeTom

9 ай бұрын

Really apprecaite that mate, glad you enjoy the content

Nice snatch Tom 😊 I havnt got the balls to do it 😂 Good video as always pal

@PlumbLikeTom

9 ай бұрын

Thanks for the support as always mate, It is easier with two I find, shared responsibility when it all goes wrong

Another enjoyable video Tom, again thanks for all the effort’s you go to. 👏👏

@PlumbLikeTom

9 ай бұрын

Thanks for the support as always Andy 👍

Hi Tom, a nice take out there Tom, like yourself I always enjoy examining the old pipe work while removing it. It’s even better when it’s time to weigh it all in. The underfloor heating jobs are always interesting for me, I haven’t done much of that and I’m a bit to old to get involved now. Another great film thank you Tom, have a great week and as always take care. 👍👍👍

@PlumbLikeTom

9 ай бұрын

Thanks for the support as always Chris, the weigh in should be nice at the end of this month, I've had a few good strip out jobs, I much prefer working in older buildings and enjoy figuring out how stuff was done originally, have a great week mate

Fair play snatching that immersion.

@PlumbLikeTom

9 ай бұрын

Thanks for the support as always Paul, it is greatly appreciated 👍

Tom you look stressed out mate, take some time for yourself and relax, nothing is more important than your health 💪

@PlumbLikeTom

9 ай бұрын

Thanks for the support as always mate

Nice snatch job on the cylinder Tom, Brilliant video as always mate, Lots of Beers 🍺 money in the scrap 😂 👍👍🤜

@PlumbLikeTom

9 ай бұрын

Thanks for the support as always Tony, not a big drinker but could do with a new watch strap, might have to treat myself

Great video Tom. You can't beat a good rip out with plenty of scrap - car boot money 👍😎

@PlumbLikeTom

9 ай бұрын

That's it mate, thanks for watching as always PB 👍

Excellent video, with an interesting range of jobs. Impressive immersion snatch - only for those that know what they’re doing!

@PlumbLikeTom

9 ай бұрын

Thanks for the support as always Steve, they can go wrong, to be honest I wouldn't normally do that but this was basically outside and the water was only luke warm

Good content as usual mate, brave snatch that Tom, hats off to you👍🏻

@PlumbLikeTom

9 ай бұрын

Thanks for the support as always mate, It was brave if it went OK, stupidity if it went wrong

Sorry to hear you're having a rough time. Hope things get better for you. Always interesting seeing quirky properties. 👍

@PlumbLikeTom

9 ай бұрын

Thanks for the support as always mate, it was just a bit of a stressful week

Busy busy there Tom .nice job on the under floor heating pipes. Ripping out is always a pain 👍👍👍

@PlumbLikeTom

9 ай бұрын

Thanks for the support as always John, the only good thing with ripping out is the scrap

Brave man taken that immersion snatch on 🤣 I’ve seen those immersion just spaghetti and become a nightmare to come out so many times , as a heating engineer even I had anxiety 😅

@PlumbLikeTom

9 ай бұрын

I've had that too mate, this one was only 6 months old though, I fitted it and had to swap it under warranty, thanks for watching

@BigBaz23451

9 ай бұрын

@@PlumbLikeTom nice one Tom , always great content 👊🏻

Nice one mate..too many adverts adverts adverts adverts tho

@PlumbLikeTom

9 ай бұрын

Sorry about the adverts mate, from the 1st of November creators will get more say on where adverts are put in the video, even when I turn them off they still appear on the videos, I guess google has to make money because of all the server space these videos take up, I make very little money from them, and I I'm not sponsored in any way so the actual videos themselves are not one big advert for a product if that makes sense

Plenty of scrap Tom

@PlumbLikeTom

9 ай бұрын

it's building up nicely again, thanks for watching as always mate

Interesting jobs as usual Tom, that last one will be £ when you get to the scrapyard 😊 hope you have a better week, the ups and downs of plumbing🪠🚽👍

@PlumbLikeTom

9 ай бұрын

Thanks for the support as always mate, I do need another weigh in soon, last week was a bad week, a few jobs that I wasn't happy with what other trades had done

Simple check with a meter.

@PlumbLikeTom

9 ай бұрын

You are right, I swapped this one out as it was under warranty, no charge for the customer

@johnturrell942

9 ай бұрын

@@PlumbLikeTom top service 👌

Pound to a penny if I did that snatch, I would have cross threaded it --- hope this week is better for you.

@PlumbLikeTom

9 ай бұрын

They can go wrong, thanks for the support as always Alan

🤘😎🤘

@PlumbLikeTom

9 ай бұрын

Thanks for the support as always Wayne 👍

Did the PRV from the boiler tee into the return in the loft with a remote PRV fitted ?

@PlumbLikeTom

9 ай бұрын

No, that's as it was mate, the heating pipes went down, shocking install really, thanks for watching