Келесі
- 28:28
- 934 М.
- 21:28
- 358 М.
- 00:35
- 12 МЛН
- 21 күн бұрын
- 00:35
- 21 МЛН
- 24 күн бұрын
- 00:41
- 10 МЛН
- 16 күн бұрын
- 00:36
- 36 МЛН
- 20 күн бұрын
- 19:00
- 2,2 МЛН
- 21:04
- 431 М.
- 15:11
- 2,3 М.
- 24:32
- 624 М.
- 25:07
- 1,9 МЛН
- 11:54
- 3,3 М.
- 17:08
- 203 М.
- 30:04
- 2,2 МЛН
- 00:35
- 12 МЛН
- 21 күн бұрын
Пікірлер: 6
That is definitely a close fit. My only concern would be for heat expansion causing it to foul. But, I doubt it would see enough heat for that to happen.
@wilsworkshop
2 жыл бұрын
It has around .040 so it should be fine, I should have measured and trimmed though.
I use an oxy torch and heat the race while spinning the hub and the race will usually just fall off no pounding or chiseling needed.
@wilsworkshop
2 жыл бұрын
Good tip, it would make it easy to do the "blind bearing" design hubs with no relief for a chisel to fit.
Do the wheels usually sit forward in the wheel well like that or is it the angle of the camera?
@wilsworkshop
2 жыл бұрын
I think it's just a combination of camera angle, and the other corners of the car on jack stands.