4430 JD, Air Seat install, Quad range transmission tear down.
the seat is really comfortable and a big upgrade from stock. the wife is light enough that she had a hard time with the old spring ride to get it to slide down, if the seat was set for my weight she was on a solid board. now with air she can lower it and slide forward.
got the transmission tore down and it looks like all i need is B range gear and bearings. otherwise shift collars, and things looked good. i will put syncro disks on topshaft
Пікірлер: 57
I'm about to install this seat in a 4230 and you're the only person who's given better direction than that paper did! Thank you for your service!
Howdy Jon. These are interesting to me in case I have ever get bigger problems than I have already. 🤣
I bought a 4430 quadrange a few months ago I’m getting ready to tear down. Wasn’t going in gears very well so I just replaced cab mounts, seemed to help but it still comes out of c range. I also have to replace the hydraulic filter every couple hours even after I’ve drained the fluid and put new in, I’m getting a lot of sliver looking fluid out each time I have to change the filter.
I used to do a lot of those transmission & rear ends, so many I didn't need the book at all to set torque specs or preload and end play. I really enjoyed that kind of work back in the early 80's, I still like wrenching.
👍The most important part inside a tractor.
I'm guessing your skill has saved you tens of thousands in repair bills. Very impressive!!
All I got got is wow. Haven’t ever seen a rear end torn that far apart before!
Jon and poison that's been awhile!!
I would love to do the seat upgrade on my tractor
How can you work on that trans with all that dirt and chaff around the top edges? I'd have all that down inside the case in no time. Guess I'm a clean freak but I like to steam everything off before opening things ub.
How did you route the wires to keep them hidden for the seat compressor?
If you look at the cabs of modern tractors now... you could fit a lazy boy in there😂
That must be an early 4430? It'll be nice when you get it done.
1000 piece jig saw puzzle, (not for children, batteries and tools not included) :)
Hello, couple months ago i bought john deere 4040s, and yesterday the "c" dosent work on 1,2,3,4 but on r1, r2 normaly work, can you help me whot i shuld to do with this Gear?
Hi Jon. Is that seat kit from k&m by chance. I had a lot of the same problems with the nuts for spacers and bolt heads in the way figment issues.
Grate video
Do you have a part number for the green piece you installed to widen the seat well
Cool!
My 4440 just started acting like it doesn't want to go from b3 to b4 when I'm pulling something. Is this a start for something bad about to happen?