I like all the Self-Sourcing you do!!! And not just going with what’s out there🤩

@fox-body

Жыл бұрын

Thanks😁

Good info!

Hopefully we will be making it to the track soon.

@itsreallytheo

Жыл бұрын

If I would’ve known those maxspeeding rods would hold up I’d go that route for a shits and giggles build lol good shit though

@ilovengn

Жыл бұрын

Can’t wait for some track footy! Build is top notch!

@fox-body

Жыл бұрын

@@itsreallytheo the jury is still out on those rods. Lol. Wait till we put 30psi to them 🤣

@fox-body

Жыл бұрын

@@ilovengn thanks!

you still need to locate the source of the noise. I had to add capacitors to my ECU. later I found a bad connection on my injectors.

I just recently found this video. What size drill bit did you use, and if you don't mind, what was the thickness of the plate adapter.

👍🏼

Looking good Kris. Did you happen to validate timing once you swapped from VR to Hal? I'm curious if it changed at all between the two sensor types.

@fox-body

Жыл бұрын

Yes I I had to adjust timing. I think more so because I changed the trigger edge from falling to rising.

@mattbrobston6832

Жыл бұрын

@@fox-body that makes sense. Its impressive it picked up power from a sensor swap. Car looks like it runs hard at that psi.

Hey are you experiencing heat soak? Mine is fine when cold but once at temp it starts to lose sync. Odd because they are rated for high temp up to 140c I believe. I’m only hitting 96 and get crazy sync loss

@fox-body

24 күн бұрын

I’m not seeing that on mine.

Hey Kris are you running one cam sensor alone? Do you need both cam sensors on non vvti when running a standalone ecu or can you just use one?

@fox-body

3 ай бұрын

You only need one cam sensor.