Thank you so much Phoenix for the trick on the parking brake cable. It was always a pain in the ass for me to reassemble this. But the way you’re doing it is very easy, thanks.

Seriously, this video is a clear example of how experience is supposed to be passed on to new learners, as myself. Thank you for the video.

@melplishka5978

Жыл бұрын

Yep well done kimo lol

Thank you! That cable method was so easy. And I followed with the longest thinnest screwdriver I had and it made it go so much faster putting those springs on rather than using players. Again thanks for the upload.

This was THE BEST, CLEAREST and MOST ORDERLY method of replacing brake shoes on a 2013-19 Sentra that exists on KZread! Hope it gets tons of views. The other videos make it so much more difficult. Nice job BE HANDYMAN!

@taoshyr

Жыл бұрын

Thanks 🙏

Good job. No words needed. I'll be using this video. I seen another similar but you did it faster and better.

Thank you 👍.

Best video yet

I wish I would’ve seen this video first ! You made it easy compared to the others!

That was an amazing job. You made it look easy.

I LOVE the way you got those pin clips off. ...pause..... I HOPE I'm going to love the way you put them back on...

Great video. The best video on KZread every other video they had no idea what to do or over explained like you never seen a break before.

Great technique and very helpful, bro.

No greasing on contact points?

Exactly how i did it 👍🏻👍🏻. Awesome.

Great job ty now I have an idea. It's very helpful brotha

This video was amazing

I did everything like you did , but when I try to push the wire was to HAARDDD!!! I think I need a SMALL screwdriver like yours.. I connected both shoes with the wire , I put the clamp and then I put the other shoe on the caliper and push back, then I put the adjuster(People have to be careful in how this part goes because I put in the wrong position before when I finish it and put the tire back ...I notice when I make the other side of the breaks....😧😧 and then I have to do again to fix the problem ( take a Picture in how goes before take off the adjuster from the shoes) ...thank you for show us how to fix it.

Thank you…

Buenisimo lo haces mirar Bien simple grasias..

Got brake dust? Spray it off with a water hose first or use brake cleaner. Your lungs will thank you.

What about the hand break did you adjust also?

Great job , Is this the same set up for a 2018 sentra s

What are you checking for at the end when spinning? TIA

@whooahhbrudder

Жыл бұрын

when u put the adjuster back you want to adjust the pads to JUST barley make contact (have no space) between the rotor and pads, so he was just making sure it was a snug fit and didn’t have any play on the rotor.

Cake work

That top spring went on waaaaaaaaaaay too easily. Nice for you

Question does 2016 Sentra SV have rear shoes or pads thank you

I swear to God whoever invented drum brakes deserves a special place in hell.

🤫🤫🤫🤫🤫

Why is my drums stuck on

@dawgmentalitypodcast4923

Жыл бұрын

How did you get it off

@megaman786

Жыл бұрын

It's stuck on from too much glue. To get it off you have to weld it.