Putting Wedge behind wheels is more important than stand support. The primary hazard is wheel rolling, ramps are not likely to collapse.

Nice, i bougth a venza a few days ago and had no idea to change the oil filter 👍🏻👍🏻👍🏻

Never had a problem with fram filters, my mazda has 230000km and my Toyota yaris has 300000. I've used all different brands but mostly fram. thanks for the video

@nazarettos6987

5 жыл бұрын

I totally agree with you. I buy more expensive Fram filters like extra guar or tough guard and no problems.

Nevermind lol I didn't finish watching the video 😂

You did a pretty good job for someone who didn't read the instructions (whoops, then later you started reading them in the middle of preparing the filter) and likely didn't watch a bunch of other videos on the subject first. You're using a properly designed oil filter cap wrench and you did not use a tool to remove o-rings which is the right way to do the job (no pick or screwdriver). Guess I spoke too soon-then you grabbed a screwdriver!

What a different kind of oil filter! Glad I checked you video before I started. Very thorough presentation. Thanks!

@nazarettos6987

4 жыл бұрын

I always use Fram oil filters but more expensive ones like Ultra or Gold

great video thanks bro

@nazarettos6987

6 жыл бұрын

Raul anthony you welcome,more videos will be posted.

THANK YOU SO MUCH

@nazarettos6987

6 жыл бұрын

saad alsaedy I am glad i could help. I just want to point it out,there are many people out there who will tell you that Fram full synthetic filters are crap,bu it's their opinions. I have been using Fram more expensive synthetic oil filters for many miles, no problems. Also as you can see in my video, Rhino ramps are awsome.

The drain plug on the oil pan has a crush washer that needs to be replaced each time you take out the drain plug. You didn't seem to know what it was- you called it a rubber washer.

@calitaco

3 жыл бұрын

Toyota doesn't use a crush washer for their drain plugs like Subaru does, it's a paper/fiber type washer. They are awesome washers, I reuse them for a few oil changes and never had problem with them leaking. I wouldn't do that on the crush washer type washers though.

Kool

Last step is start the engine- wait for the oil pressure indicator to go off- 10 seconds max- and check underneath for oil leaks before backing off the ramp and turning off the engine. This was an excruciating and inept oil change and way too long. When the vehicle is on flat surface and oil filter is full from running the vehicle , and 10 minutes go by for the oil to drain down from the top of the engine- check the oil level again.

As a general rule, never use fram. Their higher end stuff is okay, but not advised.

@nazarettos6987

Жыл бұрын

I always use Fram Extra guard or tough guard. This topic on oil filters and oil is like religion to some people.

You forgot to put in a new oil drain plug gasket/crush washer.

@nazarettos6987

4 жыл бұрын

I used same one,just turned it over.

Informative video and putting the jacks in place as a safety backup measure was good too. However the most important safety item your overlooked, blocks for your back wheels to prevent your car from rolling back.

@nazarettos6987

4 жыл бұрын

True,but I used ebrake.

@njsongwriter

4 жыл бұрын

Don't need any of that stuff when you're on ramps. It's in Park plus the parking brake is engaged. Plus jack stands which are also not needed but would act as wheel chocks if anything impossible was to happen.

@waydmah9561

4 жыл бұрын

@@njsongwriter STILL NEEDED IN CASE YOUR PARKING BRAKE FAILED ! STUPID !

@njsongwriter

4 жыл бұрын

@@waydmah9561 So I'm stupid. Even if the parking brake failed it's still in Park and he has jack stands under it which would act as chocks. How many back-up measures do you need to take? If you park on a hill on a public street do you chock your wheels? I'll bet you don't. If you're working under the front of your car and for some reason the car rolls backwards off the ramps is it going to roll onto you? No, it's going to roll away from you. Now I'm not going to call anyone stupid but... Hello McFly...

@tkrdg7885

3 жыл бұрын

Usually DOUBLE security methods are utilized. I have only one set of key to my car. So i plan to get second set of key as backup, though i have never ever lost car key, nor home key.

It looks like a spot for the driver to fit into. Do you need that tool?

@nazarettos6987

5 ай бұрын

What are you referring to?

FIRST THING YOU DO IN AN OIL CHANGE IS TAKE THE TOP FILLER CAP OFF FOR BETTER DRAINING !

A little advice from down under, its the same set up as my Highlander so don't over tighten the oil filter housing.10-20-30nm. You will need to convert that to your foot pounds. 10 on the filter drain. 20 on the filter housing. 30 on the sump plug.

@nazarettos6987

4 жыл бұрын

Thank you for advice,I'll be careful next time.

@njsongwriter

4 жыл бұрын

The numbers you gave are ft.lbs. Drainbolt on oil pan = 30 lb.ft. Oil filter cap = 18 lb.ft. Oil filter cap drainbolt = 9 lb.ft.

@Celtic-Lion___

7 ай бұрын

Tape weight torque. In all reality it's pounds per square inch😮 or cubic ft. So it's 18ft ^3

@Celtic-Lion___

7 ай бұрын

If it's inches it's 18 in. ^3 and ft would be 1.6 ft^3 do the necessary mathematics.

@Celtic-Lion___

7 ай бұрын

The type of hand tool............. will determine your applicable force of torque that you can apply...........

This is the video how not to change oil in Venza!

@nazarettos6987

Жыл бұрын

Yea and how do you change it?

@carlovanrijk4039

Жыл бұрын

@@nazarettos6987yeah, I’m not seeing a problem with this oil change. Seems to me your Venza is doing just fine. I’m hoping to get a 2015 for my retirement vehicle. Like you, I pretty much do the majority of the maintenance myself. Wish me luck! 👍🏼

This engine burns oil bad

@nazarettos6987

Жыл бұрын

I don’t have problems with mine, i change oil on time.

@hankhill3417

Жыл бұрын

@@nazarettos6987 burns one quart every 600 miles which owners manual says is normal

No torque wrench , no gloves , o rings not gaskets , the worst filter possible ...

@nazarettos6987

6 жыл бұрын

claudiu ursescu thats your opinion. I have been using Fram for very long time,but the best one Ultra synthetic. Also you do not need torque wrench.

@butch.dieselsteak

6 жыл бұрын

Nazarettos if you would do a little research you will find out how wrong you are.

@nazarettos6987

6 жыл бұрын

claudiu ursescu i have been using fram ultra for many miles,300,ooo mikes on my cadillac.

@butch.dieselsteak

6 жыл бұрын

Nazarettos first of all fram is universally accepted as shit I don't have to argue with you , they are sold at Walmart for a reason. Second Mobil 1 , Walmart ,again is not "full synthetic". For an amateur you do a great job but just using the wrong products.

@butch.dieselsteak

6 жыл бұрын

Most major oil companies such as Pennzoil, Castrol, Mobil 1 are not fully synthetic. Most are hydrocracked oils that perform similar to FULLY synthetic oils. Truly synthetic oils ( Group VI and V) are Amsoil Signature Series and Redline oils. Mobil 1 is not fully synthetic but it does contain some synthetic base stocks. Just not fully.

a fram filter? really? kiss that engine good-bye.

@nazarettos6987

6 жыл бұрын

David Wolfs its all personal opinions,i had only good experience with this filter. I know there cheap fram for 2.99 or 5$ those are bad.

@ohiodave54

6 жыл бұрын

wix filters are the best and made in the u.s.a.! wix it or fix it.

@nazarettos6987

6 жыл бұрын

David Wolfs I was looking at different reviews and the higher-end Fram are very good I've been using it for a while but also considering Wix XP

@ohiodave54

6 жыл бұрын

wix oil filter # 57047 or 57047xp is what you need. my wife has a 2013 venza with only 20,000 miles on it.

@nazarettos6987

6 жыл бұрын

David Wolfs thanks man,ill check it out.