Thank you, very helpful, last time I did one on a versa was a 2009, still had the wire harness for aftermarket lights, but I did it the way the kit told me!

Hi I would just like to say I enjoyed your video it was very educational I install the same type of lights on my Nissan versa but what I did was I hardwired I connected the lights to my parking lights so when I turn on the parking lights they come on I Have not had any problems

Thank for your. video tutorial,

Thank you i have 2016.i think try hook mine to my park lights.kept up video .great job..

@adrianmejia3302

5 жыл бұрын

Thank you and yes with parking lights it’s just less wiring. In the comments some others say how to get to the grommet under the steering wheel

I think the reason of the gap is because you attached the light on the back of the bumper instead the front?

next time remove mud guard from behind the driver front tire by removing the plastic clips. then above the hood latch wire is a rubber cover for easy access through the fire wall. then inside the car under the steering wheel follow the hood latch wire and then slightly to the left of that wire you would be able to feed your wire through with ease. thank you for letting me know were the extra red wire went couldn't figure it out and didn't have a digital volt meter. thanks and home that info helps for you next project.

@adrianmejia3302

5 жыл бұрын

Manuel Diaz thank you for this information! My girl friend had a 2016 versa note and maybe I can add Fog lights to that. I tried to go from above to that grommet under the steering but was difficult to achieve it

@michellefinn9001

4 жыл бұрын

I have a 2016 Nissan Versa note. I ran my wires and mounted my fog lights. Do u know what fuse I can tap in?

I'll use this one. Thank you!

Thank you!

Probably the best way to route that wire inside is to remove the drivers side fender, run the wires alongside the factory wiring harness for the headlights and into the same hole coverd by a rubber connector..try your best maybe use some silicone lube or spray to get the wire to push through with the factory harness into the rubber and then you wouldn’t have this clearly aftermarket random wire going through your engine bay

@adrianmejia3302

5 жыл бұрын

Tommy V yes I would’ve preferred to go through the firewall but it’s a tight fit and I had 0 help to be able to snake it through the rubber grommet under the steering column

@Cliffester

2 жыл бұрын

I just did this install on a 2013 versa note and all i used was a wire hanger straightened out and pushed it through the gromet that the hood latch travels through and went from there back to the engine bay an voila oem look.

How to adjust the aim?

I have a 2019 versa will the ones you got work?

Eh bro, what about the factory wires that are already "waiting" for user upgrade nonFogLamps to FogLamps"...?

@adrianmejia3302

5 жыл бұрын

Leonardo Arturo Meza Hernandez I haven’t seen any prewiring for my car maybe you might have the S+ or SL model that comes with it but in my case I do not.

Hey you put the wrong link in the beginning of hte video to the taking off the front bumper video. The link just comes back to this same video.

@adrianmejia3302

11 ай бұрын

I’ll look and see if I can change it didn’t notice that. Thanks!

I'm sarmad from iraq I like your working I will do for my car

@adrianmejia3302

6 жыл бұрын

sarmad ali thank you! And yes you can do the same

To all concerned if you have pre existing wire ,Just need to change light switch on the column.4 screws remove covers change switch.DIY no biggie 🤐

This might be a stupid question, but im new to car ownership. I have headlights. And i have high beams. Why would i need a third set of lights? I know, clues in the name. My current lights work fine in fog. So my question stands.

@adrianmejia3302

5 жыл бұрын

It’s meant to help you out when visibility isnt the best in fog, rain, and such other weather issues. It’s basically to help you see the road better. It’s not necessary but if you live in a place that has lots of fog it helps out a lot

buen día haber si me puedes orientar, yo quiero instalar el kit de las neblineras, pero no encuentro por donde pasar los cables hacia al tablero, espero me digas como? muchas gracias saludos desde Veracruz, ver

@adrianmejia3302

5 жыл бұрын

Hola, pase los cables por medio de los paneles (fender) asea dentro y lo pase por abajo del tablero al fuse box. Pero en el comentario, unos dicen de pasarlo por de abajo del volante.

Bro how to get the wiring into the dashboard? Which rubber gromet or hole did you use? Thanks

@adrianmejia3302

5 жыл бұрын

I wired through the fender since I wasn’t too concerned. But underneath the steering rack/column. There’s a gromet you can use.

Hello, which wire did you do the fuse tap with? Wires near the switch or after the relay?

@adrianmejia3302

Жыл бұрын

I believe it was at the fuse box that works with the switch

You never make a video for how to run the wires in to the car for plug in on the switch

@adrianmejia3302

6 жыл бұрын

Juan Perez I just showed that I ran it from inside the fender into the car and took apart the bottom cover of the dash to remove the blank space and put the button in the car.

Thx

Disculpa amigo yo tengo un problema con las luces están muy altas como las regulo..? Espero me puedas ayudar

@adrianmejia3302

3 жыл бұрын

Yo use un desarmador Philips o Cruz y cuando ves desde arriba la parte de atrás del headlight se ve un hueco con un pedazo blanco. Ahi no más metí el desarmado y se adjusta con no más apretando o aflojando. Pero no me acuerdo bien si este Versa era así o tenías que usar un dado de 10mm

Do you have a vedio on how you do the wiring sir?

@adrianmejia3302

5 жыл бұрын

Sadly no as I just showed in this video where it was all routed. People in the comments said to just take off the wheel well liner and should give you better access for the grommet under the steering wheel. Also if you don’t want your wire in the front of the fuse box then take off the 2 bolts it’s has to turn it around.

whats the name of those jacks on the wire?

@adrianmejia3302

6 жыл бұрын

Kyle Baird which one??

Hey bro I just want to ask only.you direct to battery the fog lamp

@adrianmejia3302

3 жыл бұрын

Yes it was direct to the battery as it came with a relay that goes into the cabin to add a button for it

@edabeleda2792

3 жыл бұрын

@@adrianmejia3302 so no wire it will goes to ignition switch

@adrianmejia3302

3 жыл бұрын

There’s a button that should’ve came with the kit that has 3 wires. One to the battery one to ground, and the other to the lights. But if you want to connect it to the ignition you can. Probably wiser since you could forget to turn it off. Lol

@edabeleda2792

3 жыл бұрын

@@adrianmejia3302 thanks bro for the nice Info.

How to install wiring of the fog lamps in my 2018 Nissan almera?

@adrianmejia3302

5 жыл бұрын

BOGS ROGAN DEO I ran wiring straight into the main cabin and added the switch where OEM switch would be. If you can make it through the firewall it would be best. I ran min through my fender

Wayyyy much easier adding fogs to the Note!

@adrianmejia3302

6 жыл бұрын

Automotive 101 I made this more complicated that it really is. Just wanted to make a video on how to remove the front bumper since there wasn’t any out there’s but easily could’ve just pull the of the fog covers and installed the Fog lights with the bumper attached

@michellefinn9001

4 жыл бұрын

Versa Note Depot what fuse did u tap on your versa note? I have a 2016 Nissan Versa note. I’m in stalling right now.

@wrapman_8852

4 жыл бұрын

@@michellefinn9001 I'm using a remote control kit which is way easier to install. I can make a quick video and upload it to my channel.

@michellefinn9001

4 жыл бұрын

Versa Note Depot yes Upload video please

@wrapman_8852

4 жыл бұрын

@@michellefinn9001 no problem I'll do it this afternoon.

Is really necessary removing the bumper?

@adrianmejia3302

16 күн бұрын

If you take out the splash guard you may have enough space but to do it properly it be best to remove it

Why are the lights yellow, should be bright white

@adrianmejia3302

4 жыл бұрын

Halogens they are warm white. Which has a slight yellow hue to help contrast the roads

You didn't mention where you bought the fog lights. You also never put the link on how to remove the front bumper.

@adrianmejia3302

4 жыл бұрын

www.protuninglab.com/fl-nv2015-c.html

@adrianmejia3302

4 жыл бұрын

The video was the one before I made this one. And the link is in the description for the fog lights

@mywickedness

4 жыл бұрын

@@adrianmejia3302 My Versa is a 2014, and the fog light area is different than yours. Mine are circle and pop out round, not slanted like the ones you have. Thanks anyways.

@adrianmejia3302

4 жыл бұрын

mywickedness there should be some on amazon and protuning since the manufacturer is Spec D

Adrian realiza videos en español tambien ..xd

@adrianmejia3302

6 жыл бұрын

walter canesa me gustaría ser eso pero no tengo seguidores en español :p per va ser algo que voy hacer en el futuro

Dnd conseguiste el push botón

@adrianmejia3302

3 жыл бұрын

Ya venia con el kit que compré

@ninja-gamer3669

3 жыл бұрын

@@adrianmejia3302 pero dnd compraste ese kit

@adrianmejia3302

3 жыл бұрын

www.protuninglab.com/stf0454-c.html?id=1355864836750&gclid=Cj0KCQjw6NmHBhD2ARIsAI3hrM2TTKtW4tuscMDay4wV2aL1zlALBI0B2DEGPS3vmRmd5r4Vm--kfK0aAr1uEALw_wcB

@ninja-gamer3669

3 жыл бұрын

Ok gracias, trato de acceder y no me deja

@adrianmejia3302

3 жыл бұрын

Puede ser si vives en otro país ellos no pueden vender en el país en que cives

Donde conectaste la corriente?

@adrianmejia3302

5 жыл бұрын

A la batería y a un fusible para que se apague cuando ya apague el carro.

@jesuslara7904

5 жыл бұрын

@@adrianmejia3302 a cual de los fusibles?

@adrianmejia3302

5 жыл бұрын

Jesus Lara adentro del carro si abres las puertas en el lado ese ay como un compartimento que puedes abrir y están los fusibles. Cheque cuál se prende y apago cuando enciende y apaga el carro. Esto es para mandar el poder a los focos de abajo. El ground no mas lo pone con cual quiere tuerca que esta siendo contacto con metal.

@adrianmejia3302

5 жыл бұрын

Jesus Lara mire la parte @8:00

@jesuslara7904

5 жыл бұрын

@@adrianmejia3302 puedo poner cualquiera de las dos corrientes a la bateria?

Around the door? Come on guyyy….

@adrianmejia3302

Жыл бұрын

I was not able to get it through the grommet that day.

It’s a 2019 Not a 2015 Nissan versa

@adrianmejia3302

Жыл бұрын

If you are referring to the car in the video it was a 2015 versa