**FOR PARTS** For parts used in this video and much more, please click on the description box below the video. **If you found this video helpful and would consider making a small donation to the channel cash.app/$DIYYardie paypal.me/TheDiyYardie

Thanks for the knowledge ❤❤

@thediyyardie7192

Ай бұрын

You're welcome Duende, Blessings.

Nice job. Thank you. Why did you remove the bands on the rear axles instead of pulling them out of the diff?

@thediyyardie7192

5 ай бұрын

I could have don't without pulling the bands, but I was actually trying to remove the diff without pulling the suspension or exhaust system, in the end I had to disassemble the drivers side of the suspension to get it out.

@davidbrown4868

5 ай бұрын

@@thediyyardie7192 Nice, thank you

@thediyyardie7192

5 ай бұрын

@@davidbrown4868you're welcome

Hail, mi a wonder if the drive shaft can take apart?

@thediyyardie7192

Ай бұрын

Bless up Richard, yes depending on what you trying to do, like replace the u-joint for example.

Hey thanks for the video, I have to do the same job on a 2015 Infiniti qx60, is it possible to pull the cv axles out of the differential that way I don’t break the cv axle joint boots?

@thediyyardie7192

9 ай бұрын

@hsamo713, yes you can pull them apart this same way, but you will also need pop out the ends of the axles and transfer them to the new diff, my intention was to include how to do that in my video, but somehow was unable to locate that footage while editing. Anyways you're welcome and good luck..

bless up fam, Yaad man deh ya. just asking if a 2014 Nissan rogue rear differential can work on a 2020 Nissan rogue??

@thediyyardie7192

Ай бұрын

Respect boss, yes the 2014 to 2020 is the same, as long as it has the 5.17 gear ratio.

@LyndoDiOutkast

Ай бұрын

@@thediyyardie7192 respek

@thediyyardie7192

Ай бұрын

@@LyndoDiOutkast Bless up

Did you have to do anything with the rear coil spring that sits atop of the drivers rear lower arm?

@thediyyardie7192

5 ай бұрын

Hey Jeffery, no you don't have to do anything to the spring, it will stay in place while doing this job..

Wow great job that looks like some extensive work. What’s the price on something like that?

@thediyyardie7192

8 ай бұрын

Much thanks Chris, the repair shop wanted $3000 for removal and install with a reman diff, that price covered parts and labor, I did the job for about half that price, parts and labor, helping out a good friend. There's a link in the description box above for the diff I used on this repair..

Is there any balance for the drive shift when replacing it back on the differential?

@thediyyardie7192

11 ай бұрын

No need for balance, drive shaft is machined for a centered fit, I would only worry about balancing if you have had to have that done for some reason prior or if you experience vibration while driving that wasn't there until after replacement of the diff..

the part you bought was that for the 2017 rogue i hve the same job to do

@thediyyardie7192

10 ай бұрын

Hey Jemalle, yes it was, I have a link in the description box for it, if you dont already have a replacement diff..

@TVLuxuryLife

10 ай бұрын

I just grabbed a new differential for my 2017 Nissan rogue hoping to have it installed asap

@thediyyardie7192

10 ай бұрын

@@TVLuxuryLife not that hard of a job, you can do it..

What's up bro, how high did you lift the rogue up?

@thediyyardie7192

6 ай бұрын

Hey man, about a foot and half or so..

@marcozuniga8163

6 ай бұрын

@@thediyyardie7192 got it, thanks. The junkyard had it about 2ft in the air when I pulled the diff off. My jack can only get about 1.5ft with jack and wood block combo, I should be good seeing you made it happen.

@thediyyardie7192

6 ай бұрын

@@marcozuniga8163 most definitely, and good luck with that.

Very poor quality differential. Nothing like 40s - 80s when you changed fluid if you did a repair. 10 years same fluid not uncommon. My rogue differential went out at 38,000 and again at 111,000👎🏼😥

@thediyyardie7192

7 ай бұрын

@u812green7 I totally agree with you about the quality, the really don't make cars the way they used to, and I think that is intentional. my channel is all about helping the average guy to do his or her own repairs..