Nice video. Very helpful!!

Nice job, thanks for explaining the cleaning and relubing procedure, a lot of videos omit that

Great video. Thanks a million.

very clear and specific

Thanks, good video.

I came here SPECIFICALLY to see if there was a trick to putting the caliper spring back on, and it looks like I was doing the correct procedure ("fiddle-f**k around with it for 15 minutes until you get it on") after all.

I think the torque on the caliper carrier bolts is wrong. Manual says 200 Nm. I ended up using 170 Nm + blue loctite. Also, I put lube on the slide pins like you, but one comment said no, because in this case the pins are not sealed, so brake dust will contaminate and turn it to muck. No mention of lube in service manual.

Before I push the caliper piston back, I'm going to remove some brake fluid from the master cylinder using a syringe. Is that a good idea to avoid any fluid spilling into the engine bay?

Good video

did u cut the brake pad sensor wire ??cuz i dont see there is no plug wire on there and why is there pad has sensor and still light on which mean is the rear brake low ??

@Crankyman-tu7eq

Жыл бұрын

My 2016 Passat only has the sensor on the driver's side

Dumb question, which one is easier, front or rear ?

@brendamiatapineda6407

Жыл бұрын

The front

Worst camera distance and angle 🤦. I could draw the back of your head but I could barely see what you were working on.