This will help you in not having to buy the part of done correctly
@misterx722
Жыл бұрын
does this type of switch break the circuit or connect it?
@soroilo2003
Жыл бұрын
@@misterx722 I don’t recall
@thechinchilla55303 жыл бұрын
You sir are the best, thank you so much for sharing this resourceful knowledge, greetings from Mexico!
@soroilo2003 Жыл бұрын
The ones disabling the hood switch I would suggest replacing it eventually as I had Nissan that the hood did not fully closed and swung open going up a ramp going up onto the interstate. Had to replaced the hood, windshield, and repair damage done to top of my Nissan when hood swung open.
@lindahangge27883 жыл бұрын
Thank-You so very much for sharing your knowledge 🎉
@barneynomnom59544 жыл бұрын
After watching this video i took my bracket off unclipped the sensor, drilled a hole through the side of the sensor . i then screwed a screw through the bottom of the metal spring pinning it down onto the switch, therefor basically disabling it totally . until if i decide to get a new part as having the bonnet hooked up to the alarm dont bother me so ill just leave it screwed down and disabled . its a 5 min job if you want to disable it , you could even just screw through the plastic guessing the height to pin the switch down if u wished . and now my alarm dosn't go off in the slightest bit of wind yay ;)
@grease_queendockery1483 жыл бұрын
im very proud of your camera girl :D
@PaulSampsonAU2 жыл бұрын
No need to remove the latch. The switch has two tabs at the front allowing it to be removed from under the latch.
@jamesprosser67173 жыл бұрын
Very helpful thank you!
@simonpiercy41144 жыл бұрын
I think this video will save me a huge headache
@nic_4849
2 жыл бұрын
So will selling our ranges, amirighttt????? Tough crowd?
@johnpiasecki56144 ай бұрын
Thank you so much
@emet63062 жыл бұрын
Awesome thanks for sharing 👍
@DoubleTrouble24710 ай бұрын
If you want a 2-minute fix simply bare the wires before they go into the switch and join them together then cover with electrical tape. The last two nights have been lovely being able to lock my car in silence😊
@jcioffari
6 ай бұрын
You cut the wires off feeding into that circut and tied them together? This didn't cause any other fault? Can you send a picture?
@carmend19643 жыл бұрын
Thank You 😊 I did it🥳
@newsubject89333 жыл бұрын
True story on waking the neighbors lol
@petercircee46927 ай бұрын
I won’t to pay the engineers for this fucking design
@scottymav63895 жыл бұрын
Thanks so was the bonnet open signal gone after that? since your video ended without showing if it was still there. I have the same issue with my LandRover Discovery 3, the car alarm randomly goes off at night so i think i need a sensor replacement & also to fix the clip as you just showed.
@rjright73735 жыл бұрын
You can also just put a paper-clip into the connector with the 2 wires, to short it out, tape it up and never have to worry about it again as the computer will think hood is always closed. Quickie fix for free!
@alexandralittle9050
4 жыл бұрын
video??:)
@swizzle7500
Жыл бұрын
Can’t you just pull a fuse instead?
@chrismad13444 жыл бұрын
You no need to remove the latch ,I temporary fixed my jumping those connector wires from the SW until my replacement arrive
@michelbonnet3787 Жыл бұрын
You don't need tu remove the latch ! Just remove the face grill (no tool needed) and no risk to break the bottom pins.
@prHowarth Жыл бұрын
Question: we have a 2011 Range Rover Sport. But on the passenger side, we do not have a fluid bottle w yellow cap -like you do. Do your instructions still apply to our car?
@RocioRodriguez-si3hj2 жыл бұрын
Helpful video bro, good looks.
@chevonhumphrey2216 Жыл бұрын
do this also work for a 2009 Range Rover Sport hse
@tinafisher979 Жыл бұрын
Do u have the part number by chance?
@mrsteel102135 жыл бұрын
Does that latch adjust up and down . reason i ask my hood bonnet is a bit higher on one side than the other.
@soroilo2003
5 жыл бұрын
There is a little bit of an adjustment on the one I have
@mrsteel10213
5 жыл бұрын
soroilo2003 Cool i figured it would i might just need a new latch since my hood bonnet does raise up about 1/4 of an inch. you reminded of me with my daughter always a helping hand when she was younger. Now as a teen its rare. Enjoy your kids when theyre young. Thanks for the reply brother.👍🏼
@ROY-COLLEY5 жыл бұрын
Why didn’t you just remove the grill ? You took the top part off ,all you had to do is pull out the bottom and it comes off easy. You would have had much more room.
@soroilo2003
5 жыл бұрын
Yes it is very easy to remove grill just didn't know it was that easy at the time I did this video
@motomomo33 жыл бұрын
Mannnn change ur title to range rover sport! I keep coming across ur video thinking its for a L322....
@johnjohannemann12202 жыл бұрын
Apparently you knew ahead of time what the failure was so why not have the parts ready and install them in the video. Doing double duty and twice the work is not cost or time affective.
@stuarth433 жыл бұрын
PLEASE CALL A SCREW A SCREW NOT A BOLT A BOLT HAS A NUT ON THE END , THANKS FOR VID
Пікірлер: 37
This will help you in not having to buy the part of done correctly
@misterx722
Жыл бұрын
does this type of switch break the circuit or connect it?
@soroilo2003
Жыл бұрын
@@misterx722 I don’t recall
You sir are the best, thank you so much for sharing this resourceful knowledge, greetings from Mexico!
The ones disabling the hood switch I would suggest replacing it eventually as I had Nissan that the hood did not fully closed and swung open going up a ramp going up onto the interstate. Had to replaced the hood, windshield, and repair damage done to top of my Nissan when hood swung open.
Thank-You so very much for sharing your knowledge 🎉
After watching this video i took my bracket off unclipped the sensor, drilled a hole through the side of the sensor . i then screwed a screw through the bottom of the metal spring pinning it down onto the switch, therefor basically disabling it totally . until if i decide to get a new part as having the bonnet hooked up to the alarm dont bother me so ill just leave it screwed down and disabled . its a 5 min job if you want to disable it , you could even just screw through the plastic guessing the height to pin the switch down if u wished . and now my alarm dosn't go off in the slightest bit of wind yay ;)
im very proud of your camera girl :D
No need to remove the latch. The switch has two tabs at the front allowing it to be removed from under the latch.
Very helpful thank you!
I think this video will save me a huge headache
@nic_4849
2 жыл бұрын
So will selling our ranges, amirighttt????? Tough crowd?
Thank you so much
Awesome thanks for sharing 👍
If you want a 2-minute fix simply bare the wires before they go into the switch and join them together then cover with electrical tape. The last two nights have been lovely being able to lock my car in silence😊
@jcioffari
6 ай бұрын
You cut the wires off feeding into that circut and tied them together? This didn't cause any other fault? Can you send a picture?
Thank You 😊 I did it🥳
True story on waking the neighbors lol
I won’t to pay the engineers for this fucking design
Thanks so was the bonnet open signal gone after that? since your video ended without showing if it was still there. I have the same issue with my LandRover Discovery 3, the car alarm randomly goes off at night so i think i need a sensor replacement & also to fix the clip as you just showed.
You can also just put a paper-clip into the connector with the 2 wires, to short it out, tape it up and never have to worry about it again as the computer will think hood is always closed. Quickie fix for free!
@alexandralittle9050
4 жыл бұрын
video??:)
@swizzle7500
Жыл бұрын
Can’t you just pull a fuse instead?
You no need to remove the latch ,I temporary fixed my jumping those connector wires from the SW until my replacement arrive
You don't need tu remove the latch ! Just remove the face grill (no tool needed) and no risk to break the bottom pins.
Question: we have a 2011 Range Rover Sport. But on the passenger side, we do not have a fluid bottle w yellow cap -like you do. Do your instructions still apply to our car?
Helpful video bro, good looks.
do this also work for a 2009 Range Rover Sport hse
Do u have the part number by chance?
Does that latch adjust up and down . reason i ask my hood bonnet is a bit higher on one side than the other.
@soroilo2003
5 жыл бұрын
There is a little bit of an adjustment on the one I have
@mrsteel10213
5 жыл бұрын
soroilo2003 Cool i figured it would i might just need a new latch since my hood bonnet does raise up about 1/4 of an inch. you reminded of me with my daughter always a helping hand when she was younger. Now as a teen its rare. Enjoy your kids when theyre young. Thanks for the reply brother.👍🏼
Why didn’t you just remove the grill ? You took the top part off ,all you had to do is pull out the bottom and it comes off easy. You would have had much more room.
@soroilo2003
5 жыл бұрын
Yes it is very easy to remove grill just didn't know it was that easy at the time I did this video
Mannnn change ur title to range rover sport! I keep coming across ur video thinking its for a L322....
Apparently you knew ahead of time what the failure was so why not have the parts ready and install them in the video. Doing double duty and twice the work is not cost or time affective.
PLEASE CALL A SCREW A SCREW NOT A BOLT A BOLT HAS A NUT ON THE END , THANKS FOR VID