2011 Dodge Grand Caravan Oil Filter Housing Replacement

Автокөліктер мен көлік құралдары

This wasn't too bad, had a few electrical and hose connectors give me a fight but not too bad for how much you need to take off to get to the part.
Amazon Affiliate
oil filter housing
amzn.to/3OAcJWM

Пікірлер: 12

  • @scotthancock6764
    @scotthancock67646 ай бұрын

    Thanks for the video. I watched this and a couple more and think I can tackle it.

  • @genecampbell3070
    @genecampbell3070 Жыл бұрын

    Only thing I see is didn’t undo negative battery cable….rule of thumb is always undo negative ground cable before any maintenance is done….but considering what is being done it’s not a pressing issue and all around good video

  • @AdanGarcia-oo8zh
    @AdanGarcia-oo8zh Жыл бұрын

    Could you please let me know where exactly goes the little spring that is inside of the oil filter housing???...I guess I just FT..😢😢😢...thank you in advance

  • @kevinnivek1953
    @kevinnivek1953 Жыл бұрын

    I am going to be doing this myself tomorrow but I was told by a mechanic that the oil needs to be changed afterwards due to antifreeze getting mixed into it after replacing the housing. Isn’t there a way to stop the antifreeze from getting mixed in the oil? The oil was just changed on the vehicle and I would hate to have to change it again.

  • @mikemaj8467

    @mikemaj8467

    Жыл бұрын

    Mechanic is not entirely correct. Depends on where the failure is on your oil cooler. It is most likely leaking coolant externally which is dripping from the center of the engine then over the transmission housing. If this is the case, like mine was, prior to installing a new housing check your oil dipstick to see if it looks like a milkshake. If not, I believe you can change the housing, then top off coolant and oil levels. You should lose very little oil when doing this housing swap. Remember, most of the oil is in the oil pan.

  • @aleksikabadozov5932
    @aleksikabadozov5932 Жыл бұрын

    Did u have to drain the coolant as well

  • @adamanderson8631

    @adamanderson8631

    Жыл бұрын

    I didn't, just let it leak a little and topped it off when I was finished.

  • @joeprevost8284
    @joeprevost8284 Жыл бұрын

    Can I get the link for that part?

  • @adamanderson8631

    @adamanderson8631

    Жыл бұрын

    Yup its in the description

  • @ericksenkmajer3414
    @ericksenkmajer341410 ай бұрын

    This is an "okay" tutorial. It would have been far more helpful to show the screws, bolts, and nuts to the camera before you reinstalled them, perhaps even take a moment to point to (and move the camera) to where they were being reinstalled. At least include the parts tray in the shot. I am "handy," but I have never done this job before and there were 3 days in-between disassembly and the arrival of the part I needed. A little reminder before each one would have been great.

  • @aaronthehef7725
    @aaronthehef77252 ай бұрын

    Something something torque inch pounds lol 😂

  • @teresabellar9191
    @teresabellar91917 ай бұрын

    Light is not very good or the vow

Келесі