2007 Toyota Rav4 Lower Control Arm Replacement
Hi guys and welcome to this episode
Thanks for watching and don't forget to Subscribe.
Camera that I use for this video Sony RX100.
amzn.to/2WlTx50 Impact Gun
amzn.to/2AU3BZC Jack Stands
------------------------------------FOLLOW ME---------------------------
Follow me on Instagram
@bulletsolano36
Follow me on Twitter
@bulletsolano
Like my Facebook page
/ luis.b.solano.3
Thanks for watching.
Disclaimer
This video contains tips and recommendations only
Bullet Solano Shall not be liable for any harm, injury damage or if anything bad happens to your vehicle or property got in the process of repair and replacement due to use or misinterpretation of the information on this video.
Keep in mind that if you buy low quality auto parts does not guarantee the adequate level of road safety.
Пікірлер: 31
Thanks man! I have a 2010 rav4 and was going to rebuild the front suspension system in the spring. This video helps out a lot!
Excellent video my friend. Very clear instructions, step by step. I appreciate you!!
Thanks for sharing, very helpful
Mine is a 2008, and RHD, but those differences I do not think would make the problems I had.
nice informative vid. Thanks for putting it together.
Thanks for this, Bullet! Very helpful. Is this a 4 cylinder or the V6? Most of the posts I've seen mention removing the oil/transmission fluid pan to access the long horizontal bolt.
nice share!
I have a 2011 with a V6, automatic. Would it be simpler to drop the oil pan than the sub frame? I am doing this with jacks and not a lift.
Did you have to lower subframe for replacement of the driver side front control arm? Great video; hope mine is that easy!
Is it v6 or 4 cylinder. Which ones have a notch in the oil pan?
new one different from the old ☝️ one. much thinner arm. and bushings are pushed all the way in the rear one. arm wan’t be levelled did any problems after you replace arm???
Hi: I have an 2007 V6. For both sides, do you have to lower the frame on a V6 or take off the oil pan or transmission pans to replace arms?
How exactly do you lower the subframe?
Good vidío xD ;v ;v