No video
2007 Seadoo GTI 4tec Ride plate Remove and Replace (Detailed)
Hello all. Here is a full video how to to remove and replace a ride plate (Heat exchanger) for a 2007 Seadoo GTI 4tec. Customer was riding normally and smack into a large rock underneath the water. It began to leak coolant and turn on the engine light!
Пікірлер: 15
Great video. I found my ride plate at Water Works plus pipes and rubber o rings. I also wanted to include I used a smaller copper pipe cutter (after removing the cutting wheel) to squeese the ring clamps. They are stout so I also used small channel locks to turn the wheel to compress the spring. Once you get them placed over the clamp and tighten by hand they stay in place.
Great video. Thank you for taking the time to make it. It helped me understand my GTI better.
Time later but thank you for this video , very well explained
This video really helped me out. Thanks for posting
I know this is a few years later, but what was the wire you had to reconnect? Thanks again this is a great video
Awesome video, my 2006 gtx 215 ride plate screw cracked.. need to replace ride plate. Im ready to follow your steps 😂😂. What did you use to scrape off old glue from bottom
What RTV silicone did you use? I am also not sure what size/oz I should get
Good job 👍
@jdcauto5977
3 жыл бұрын
Thank you
Hi, I had the same happen to mine I was wondering where you found a new ride plate? I’ve only been able to find used ones on eBay.
@jdcauto5977
3 жыл бұрын
Its not EZ to find at all. But i go my plate off Ebay. I Made sure it had a 100%return promise. Just need to pick a seller that has really good reviews. I also tested it when it arrived.
@trentonvogrig7399
3 жыл бұрын
Oh ok thank you!
@nancymiller7038
2 жыл бұрын
@@jdcauto5977 what was the name of the dealer on ebay?
How many hrs was in it?
@jdcauto5977
3 жыл бұрын
If i had to do it again it can be done in about 4/5 hours