Thanks for the video. Was having an issue with a 2003 ZX6R not starting. It would crank but had no spark. Added a resistor to the gray wire and it started right up.
@phonhsuady4870
Жыл бұрын
What voltage is the grey wire supposed to have I’m getting 9 to 9.5 is that to much
@ballinb8044
Жыл бұрын
Simple, was looking for this thanks
@ballinb8044
Жыл бұрын
My bike fired right up. I was almost about to buy an ECU lol
@jodymcmurray272
8 ай бұрын
Is it the red and gray that the resister goes in between?
@blockawgold7069 Жыл бұрын
It I just use. The switch how to do it and tip over sensor lost how. Can I do it with out the part and. I do the same e thing with the restor
@user-du1uq2eo2u Жыл бұрын
I doubt it actually runs. I got the same problem but the immobilizer won't allow it to run. It'll crank but it won't run.
@DaveArnoldphparray
9 ай бұрын
Mine runs fine with this setup.
@jordanmcbride112910 ай бұрын
How can I find which wires are for my blinkers ? It’s been cut before for different blinkers and I want some on it now and don’t know how to find the blinker wires
@DaveArnoldphparray
9 ай бұрын
Sorry, I need to get better at seeing comments on here. I believe the front right positive is grey and front left is green. The negatives should be black/yellow or just black. Use a test light or a multi-meter to verify with the signal switch on.
@ChristopherBurr-ce1rm Жыл бұрын
Hello are you available for questions
@sagemata5756 Жыл бұрын
Can you dumb down your wiring diagram I’m medically diagnosed dyslexic so that made zero sense😂
Пікірлер: 13
Thanks for the video. Was having an issue with a 2003 ZX6R not starting. It would crank but had no spark. Added a resistor to the gray wire and it started right up.
@phonhsuady4870
Жыл бұрын
What voltage is the grey wire supposed to have I’m getting 9 to 9.5 is that to much
@ballinb8044
Жыл бұрын
Simple, was looking for this thanks
@ballinb8044
Жыл бұрын
My bike fired right up. I was almost about to buy an ECU lol
@jodymcmurray272
8 ай бұрын
Is it the red and gray that the resister goes in between?
It I just use. The switch how to do it and tip over sensor lost how. Can I do it with out the part and. I do the same e thing with the restor
I doubt it actually runs. I got the same problem but the immobilizer won't allow it to run. It'll crank but it won't run.
@DaveArnoldphparray
9 ай бұрын
Mine runs fine with this setup.
How can I find which wires are for my blinkers ? It’s been cut before for different blinkers and I want some on it now and don’t know how to find the blinker wires
@DaveArnoldphparray
9 ай бұрын
Sorry, I need to get better at seeing comments on here. I believe the front right positive is grey and front left is green. The negatives should be black/yellow or just black. Use a test light or a multi-meter to verify with the signal switch on.
Hello are you available for questions
Can you dumb down your wiring diagram I’m medically diagnosed dyslexic so that made zero sense😂