There's no telling how many people you stopped from disassembling the entire dash only to find no expansion valve under there. Great video and highly appreciated!!!

very helpful video. doing the same thing to my car currently and this is the only video I have found. thank you for sharing, quoted cost: 2200, DIY cost: 350

Thank you so much for this video... Being a woman working on a vehicle but being frowned upon by many repair places when asking about the process verses the prices, it comes in handy to have this viewing knowledge! Im attempting this valve expansion replacement since I've already installed the compressor but can't wait to see the install video... Thank u again!

@Aaron-fb6mb

2 ай бұрын

How’d it go?

I learn alot from you thank you LORD be with you .🫵🫶 yor video. the tool to take those hose out is 2 sharp pin by amazon

Savior for showing how to replace the expansion valve 👌

Thank you for the great explanation of where each part is located. The expansion valve is the part, i have dreaded from working on due to the same thing you have heard, about having to take the dash apart. Thanks for the video.

Couldnt have uploaded this at a better time. Mine just went out as well. Thanks 🤙

Thank you brother. Thank you so much. I have a 2005 xb and I have too take the condenser out. And I thought it was in the dash.

This is a great video, thanks for the information!

Thx! Good to see what it takes.

My AC failed last June to, thank now ill order all three parts .

Thank you for making this video

Wow thank you so much,for that video.

Thank you! I was about to rip my dash off!

Ty this video helped me from taking the whole dash apart lol

🙏 thank you...

Not everyone knows they switched from a low flow expansion valve (Denso 447500-1600, Toyota PN 88515-52010) to high flow expansion valves (447500-2090, 447500-2540, 447500-2740, 447500-3060, Toyota PNs 88515-52020 and 88515-52040) on this vehicle. Supposedly to improve refrigerant flow control at low heat loads since the car has a variable displacement compressor (a very small TXV opening at low evaporator heat load means more hunting and this causes issues with the compressor's displacement control) and also to provide better cooling at idle since more refrigerant flows through the evaporator and the variable displacement compressor is always running. They also made different valves featuring a low flow control charge for vehicles equipped with fixed displacement scroll compressors (447500-2390 and 447500-2850) to aid with evaporator pressure pulldown as the clutch cycles off and on. A high flow TXV is identified by numbers 2 and 8 on the power head (the metal disc) and sometimes the letter H too (i.e 2H8=high flow). Done a lot of testing on these Denso valves since i wanted to find a suitable replacement for another vehicle.

Shop just quoted me $2000 for this exact repair. Hoping to do it on my own

Great video! Mine is an xA but this is exactly what I needed to see. btw, did you notice that allen bolt holding the expansion valve assembly together fighting to the the bitter end to come out? It almost feels as though it's stripped. Thanks for take the time to post this.

@Hooghol

2 жыл бұрын

Same problem here did you managed to get yours out from the engine side or did you had to strip the Dash?

Thanks

Fucking life saver man. I as well thought I was going to have to dismantle the sash. I own. a07 scion xa. So this seems to be my solution. thank yiu!

My '06 box has 106k on it and I'm on my 3rd compressor. They don't last long in South Texas heat. Though when it comes time for the 4th unit next year, I might do the job myself this time.

@teravolt6113

4 жыл бұрын

Check the hoses, you might have delaminated hoses that prevent proper oil return killing your compressors. And replace the condenser and dryer

What is the ac line called that goes into the firewall?

Is this the entire system other than lines?

Who did you buy the parts from to get the lifetime warranty? Napa? And after the pulled a vaccum on it did you have to change the evaporator coil too?

I just bought a 05 xb. The air was kinda working when I bought it, so I thought it just needed charged. I charged it then I sprayed out of the compressor out of the bolt w two holes on the bottom. Would this mean I need a new compressor now? It has 100k on it.

I have the same 06 scion xb my question is my ac condenser just leaked out all my freon and I have been driving for a few weeks with no a.c. I bought the ac condenser and do you think my ac compressor is no good anymore? My issue was only a leak on my ac condenser but I don't know if me driving with the compressor spinning kills it. Thanks.

That Allen cap bolt on the expansion valve is stuck on my I might try to use a impact next...If that does not work then I guess the stupid dash will be coming out.!

Why you got a Fram filer?

Thanks for the video, it was very helpful in identifying the components needed. You didn't mention where you sourced your kit from, do you mind saying where you got that particular one?

@tonycrumrine9947

2 жыл бұрын

I purchased my kit from Autozone.

@grimgodley5481

2 жыл бұрын

@@tonycrumrine9947 thanks,man. Any issues since the install?

@tonycrumrine9947

2 жыл бұрын

@@grimgodley5481 I seem to have to charge the system about once per year. I don’t actually get why, because when I hook up the charging canister my levels are still in the green area on the gage. But the system does not blow cold unless I charge it to the very high end of the green almost into the red. But otherwise it is still good.

@grimgodley5481

2 жыл бұрын

@@tonycrumrine9947 That's good to hear. Maybe moisture leaking into the system during the winter might be the culprit. I've heard you're suppose to run your ac at least once a month for 15 minutes even in the winter to keep it cycling properly but I've never had a chance to test this theory. Thanks for the replies, dude.

Hi what did you use to remove the freon before removing the compressor

@tonycrumrine9947

4 жыл бұрын

H C the shop that charged the system when it was done, used a vacuum pump to clear the system before I started.

Thanks for the video. My AC works fine, but yesterday my serpentine belt frayed making lots of noise driving home from work. Upon inspection, I found the ribs of the clutch pulley were broken. I can only imagine a rock got caught in there at one time. Anyways. I need to replace the pulley on the compressor. Looking to source one at the local pick&pull. It looks like Toyota used a non-standard recessed bolt in the AC Clutch. do you have any knowledge on how to remove the clutch from the compressor? Really don't want to purchase a new compressor and evacuate the system. Im in Central Coast of Ca & can get by w/o AC, so I may just run a shorter belt and abandon the AC to avoid the high cost of replacing the compressor...

@tonycrumrine9947

4 жыл бұрын

Kelly McKinley I do not know much about how to pull the clutch off. It’s been a while since I did this repair but it seems like I was told that it wasn’t feasible to replace the clutch.

@bnoyz3

2 жыл бұрын

@@tonycrumrine9947 currently dealing with A/C problems on my 2006 Scion xB. Found out that the compressor doesn't have a typical magnetic clutch, so it always spins. It's a variable displacement compressor? So, I would guess that you can't just replace the clutch portion. It has an internal solenoid that regulates the flow of freon i believe.

Is it possible that only the compressor clutch needs to be replaced? I was stopped at a light and my car turned off, I was able to make it home. I put a shorter belt to bypass the A/C. Anyway to test it, A/C was working perfectly until it died the one time.

@tonycrumrine9947

4 жыл бұрын

Abel Briones mine basically did the same thing. Problem is the clutch is more difficult to replace if you can even find the parts. Then you also have no warranty. I gave up on clutch and just bit the bullet.

@davidcrary3171

2 жыл бұрын

You don't happen to remember the part number for the shorter belt, do ya?

Just don't buy a Murray(defective pos from O'Reilly) I have been a professional technician for over 20 years I would rather roll the dice on an autozone compressor that one may work out of the box???? But you will be returning the Murray if you buy that pos!

Does the 2004-2006 use the same condenser?

@tonycrumrine9947

5 жыл бұрын

anonymous mc I would assume so. The new condenser was larger and the bottom mounting points fit differently, but it did still fit.

When the compressor went bad did the ac light on the ac button go out as well? Brought my xB with a bad compressor and the light never lit up for me... wondering if it will go bad on once replaced or if i need to find the appropriate fuse.

@tonycrumrine9947

6 жыл бұрын

Nathaniel Brown when the compressor went bad, it just started making a very bad growling noise like a bearing was about to seize up. It did this very suddenly and in my two to three mile drive home it got worse and even liked the engine at one point. The engine did restart and I was able to drive it home. The button always functioned properly.

Dang! This does not look tough. I'm getting quoted 2100 bucks to do this. 😑