1971 El Camino Carbed LS-T56 Swap Part 1: Test Firing, Cleaning, and Prepping the Aluminum 5.3
Автокөліктер мен көлік құралдары
Today we’re getting the El Camino’s first of many LS engines fully dressed and ready to be installed. The motor is a 2003 LM4 aluminum 5.3 pulled from Bakersfield LKQ back in October of 2021. We’re installing a full set of factory accessories from a 98-02 4th gen LS1 Camaro, a holley dual plane carb intake, ls6 PCV valley pan, Granatelli valve covers, and a Holley 302-2 oil pan.
Parts used in this video:
Intake manifold
www.holley.com/products/ls_po...
Ls swap headers
www.holley.com/products/exhau...
Carburetor
www.holley.com/products/fuel_...
Ls ignition box
www.holley.com/products/ignit...
Valve covers
granatellimotorsports.com/i-3...
Oil pan
www.holley.com/products/engin...
Ls-T56 clutch
www.advancedclutch.com/t1s-g0...
Пікірлер: 19
Guy through out like tons of knowledge first 5 mins of video👍
To the tune of Earth, Wind & Fire's - "September" There is Travis, he's revving his motor The oil, its making an odor LS motors, there are no others Ba-dee-ya ... he's waking up the neighbors Ba-dee-ya ... race gas is his flavor Ba-dee-ya ... more videos again-n-n-n 😊🙃😊
nice, had 2 elco's back in the late 80s. gf wrecked my first 71,pushed the firewall in 6 inches. yanked motor and went to a 72 that i restored. went to grafitti night in madesto late 80s when it was real! took me 3 hours to get from one side to the other on mchenry with all lanes jamb packed.
Keen az for this build
Damn man, I need an Ly6 over here in australia, Wish you were here to work on the LS engines I have.
Hey travis! Would love a LS junkyard pull tips and tricks! And the tools you usually use!
Just going this channel and have been watching it different videos of yours for the last day. Good stuff
Awesome work bro ❤
Tru GM nerd YO GOOD 👍
Very nice I ❤ carbed LS❤
is that lifter tick ?
@travisblack417
Жыл бұрын
No, the exhaust is just quiet and the camera mic picks up every little sound. It sounds fine in person.
Will the pedal be hard driving on the street
Where did you get the see-through valve covers from
@travisblack417
9 ай бұрын
Custom made by this dude instagram.com/oddrodmachine?igshid=MzRlODBiNWFlZA==
A Travis do you have a l33 block by chance
@travisblack417
Жыл бұрын
I have several but nothing for sale right at this moment. How complete are you looking for?
how much did all the parts cost in total?
@travisblack417
9 ай бұрын
All the parts are listed in the description