That’s pretty consistent. Very good.

Did your parts kit come with the gen 4 or gen 3 trigger assembly. I was watching your vids and I've seen a few people on reddit say that they mistakenly got the gen 4 trigger and had to file down a little horizontal nub on the trigger arm that pushes up on slide. Maybe that is whats catching when the slide is trying to return to locked position. If you have to pull the trigger forward to get it to close fully, I think this may help you.

Do you have the load data anywhere that I am able to access for the 200gr Flat Points? Like the OAL? Thank you.

Would you recommend the Polymer 80 45 kit? Seems reliability has been a problem for a lot of Poly 80 builds. Thanks.

@SevenStarTactical

3 жыл бұрын

I love mine. It's only as reliable as you make it. With stock Glock 20 parts it should run 100%. Anything with tighter tolerances runs the risk of tolerance stacking, which can affect reliability. My 10mm won't work with weak factory loads, bu tit's 100% with my reloads, and hot factory stuff.

@jonbaniak9097

3 жыл бұрын

I believe I’m going with frame from Rock Slide. Can’t seem to find original Glock parts for less than buying a complete gun. I’m going for a 45 slide then I’d be able to run 10mm with a simple barrel swap and mag change. Thanks again.

@357Franknitty

3 жыл бұрын

@@jonbaniak9097 JUST got my slide from them! Good stuff FYI... IN STOCK for PF45, they only have Burnt Bronze, FDE and Olive colors in. Anything else they'll let you buy, but you'll be waiting FOREVER until they get more blanks in to make em for a heads up!