Happy Holidays to ALL valve cover gasket replacement • Range Rover Sport Supe... Heater Tube - www.amazon.com/Acouto-LR01827...
Жүктеу.....
Пікірлер: 22
@h3I3RoNE_844 ай бұрын
If you still needed info on removing that cowl panel its literally just a matter of removing the 15mm nut that holds each side of windshield wipers, once you pull the wipers off you then remove the plastic push pins (4 total if I’m not mistaken) that hold the cowling. Should easily come off after that.👌
@acrepairnearme Жыл бұрын
Brilliant video
@EricLamb2 жыл бұрын
Great video !
@desertcamel3573 Жыл бұрын
Great video.
@NathanJackson-vv4iq10 ай бұрын
What are the hoses and part numbers that you would replace once you have the super charger off?
@EngineInformant
10 ай бұрын
Sorry the link has expired this may be similar amzn.to/3PhF5Hv
@NickJThibault5 ай бұрын
is there a way to know if the engine has damage before taking it apart?
@eyaooooo6 ай бұрын
The lower hose on top of the supercharger what is it called and where were you able to get one? Thank you.
@EngineInformant
6 ай бұрын
I'm not sure which hose you're speaking about if I can figure out which one it is I'd be happy to help
@vincentcelicious5675 Жыл бұрын
Hi just a question when you are bleeding is there any white smoke coming out your exhaust??
@EngineInformant
Жыл бұрын
There should be no white smoke coming from the exhaust as that usually means head gasket failure. I have had light moisture come out on initial start up which is normal from moisture buildup when its parked not running overnight
@vincentcelicious5675
Жыл бұрын
@@EngineInformant thank you for your reply I did the same and was able to replace that crossover pipe. But then again I guess my car overheated could have hurt the head gasket
@EngineInformant
Жыл бұрын
@@vincentcelicious5675 check your oil for milky color or moisture. if it was bad but not yet milky-ish, you could pull the oil drain plug for 1 second and put back and you would see coolant come out as water and coolant lay below the oil. Also make sure to bleed the air out of coolant lines. It's a PITA but utilize your bleeder valve screws. Best Of Luck!
@vincentcelicious5675
Жыл бұрын
@@EngineInformant I can do that validate the oil. Yes it was a pita bleeding that system. In your video you mentioned that there is another way to fill the heater core thru the pipe. Would it be the pipe going to the crossover pipe or backwards going to that aluminum lines?
@nickdubas67592 жыл бұрын
Any torque specifications for reinstalling the supercharger?
@EngineInformant
2 жыл бұрын
I don't recall off hand but it was listed in the repair manual. Very important as they can strip easily in the aluminum head.
@nickdubas6759
2 жыл бұрын
@@EngineInformant It's 18 ft-lbs per the Land Rover dealer
@chasingwaves112 жыл бұрын
thats the cross over coolant tube. that was leaking
@Chewie374
Жыл бұрын
No. The rear is the heating pipe
@willharris85612 жыл бұрын
Where are you located because I need you to work on mine. Pls.
Пікірлер: 22
If you still needed info on removing that cowl panel its literally just a matter of removing the 15mm nut that holds each side of windshield wipers, once you pull the wipers off you then remove the plastic push pins (4 total if I’m not mistaken) that hold the cowling. Should easily come off after that.👌
Brilliant video
Great video !
Great video.
What are the hoses and part numbers that you would replace once you have the super charger off?
@EngineInformant
10 ай бұрын
Sorry the link has expired this may be similar amzn.to/3PhF5Hv
is there a way to know if the engine has damage before taking it apart?
The lower hose on top of the supercharger what is it called and where were you able to get one? Thank you.
@EngineInformant
6 ай бұрын
I'm not sure which hose you're speaking about if I can figure out which one it is I'd be happy to help
Hi just a question when you are bleeding is there any white smoke coming out your exhaust??
@EngineInformant
Жыл бұрын
There should be no white smoke coming from the exhaust as that usually means head gasket failure. I have had light moisture come out on initial start up which is normal from moisture buildup when its parked not running overnight
@vincentcelicious5675
Жыл бұрын
@@EngineInformant thank you for your reply I did the same and was able to replace that crossover pipe. But then again I guess my car overheated could have hurt the head gasket
@EngineInformant
Жыл бұрын
@@vincentcelicious5675 check your oil for milky color or moisture. if it was bad but not yet milky-ish, you could pull the oil drain plug for 1 second and put back and you would see coolant come out as water and coolant lay below the oil. Also make sure to bleed the air out of coolant lines. It's a PITA but utilize your bleeder valve screws. Best Of Luck!
@vincentcelicious5675
Жыл бұрын
@@EngineInformant I can do that validate the oil. Yes it was a pita bleeding that system. In your video you mentioned that there is another way to fill the heater core thru the pipe. Would it be the pipe going to the crossover pipe or backwards going to that aluminum lines?
Any torque specifications for reinstalling the supercharger?
@EngineInformant
2 жыл бұрын
I don't recall off hand but it was listed in the repair manual. Very important as they can strip easily in the aluminum head.
@nickdubas6759
2 жыл бұрын
@@EngineInformant It's 18 ft-lbs per the Land Rover dealer
thats the cross over coolant tube. that was leaking
@Chewie374
Жыл бұрын
No. The rear is the heating pipe
Where are you located because I need you to work on mine. Pls.
What's the mileage?
@EngineInformant
Жыл бұрын
90k