009: SINGLE 4ga WIRE CONNECTOR BULKHEAD INSTALL
This 4ga DTHD connector can be fastened to a firewall or trunk to allow you to pass a 4ga cable through in a way that can easily be removed.
Here is a link to Devin Vanderhoof’s video that was referenced in this video: • Holley efi proper grou...
Here is a link to the product page: mavenspeed.com/collections/b2...
IN THIS VIDEO:
1: Overview, seals 0:09
2: Template/Cutting holes 0:41
3: Terminals; Pins and Sockets 1:45
4: Crimping Terminals 3:19
5: Assembly 6:18
6: Pin Removal 8:00
Пікірлер: 16
Very nice piece!
Thanks for the video
I wish this came as a dual setup for pod/neg.
thanks for the cheap tool recommendation!
Pretty sure the specked out tool for the crimping isn't 1600 I just bought it it's 300 or around there Don't remember exactly but it's from Deutsche to use on the six gauge and 4 gauge DTHD
I'm pretty sure 4ga wire should be good enough for a battery relocation, but if you have a 2ga or a 0ga that would be PERFECT
I wish this came as a dual setup for pos/neg
Wish they would make these larger! like 400A capable!
@mavenperformance
3 жыл бұрын
SovL:Remedy check out the video on the radlok series- what size of cable do you have?
If you had one 00 👌🏼👌🏼
@mavenperformance
3 жыл бұрын
Offtrac_Celica check out the video on the radlok series 👍
Do you guys plan on doing a 2 gauge one of this I would get it
@mavenperformance
4 жыл бұрын
greg harris , yes more to come- watch for a video in the next week or 2
@sonofgto
4 жыл бұрын
@@mavenperformance sweet I will be watching
Foot lbs or inch?
0